Motion RC Detrum GAVIN-6A Supplemental Manual

Transmitter

Advertisement

www.motionrc.com
Motion RC Supplemental Guide for the
Detrum GAVIN-6A
Transmitter
Version 1.0

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Detrum GAVIN-6A and is the answer not in the manual?

Questions and answers

Summary of Contents for Motion RC Detrum GAVIN-6A

  • Page 1 Motion RC Supplemental Guide for the Detrum GAVIN-6A Transmitter Version 1.0...
  • Page 2: Table Of Contents

    Calibrate the Transmitter ....................2 Bind a Receiver to the Transmitter ................... 3 Prepare to Configure the Transmitter ................3 Set Servo Direction ......................4 Set Hi or Low Rates ......................5 Motion RC Supplemental Guide for the Detrum GAVIN-6A Transmitter...
  • Page 3: Review The Transmitter's Controls

    This guide provides instructions to help you set up the Detrum GAVIN-6A to control an airplane. Additional information can be found in the manual included with the radio. Review the Transmitter’s Controls 1. Power switch—push the switch up to turn the transmitter on.
  • Page 4: Power The Transmitter

    1. Ensure that the throttle stick is in its lowest position (all the way toward the bottom of the transmitter). 2. Push and hold the trim button under the right stick all the way to the right and turn the Motion RC Supplemental Guide for the Detrum GAVIN-6A Transmitter Page 2...
  • Page 5: Bind A Receiver To The Transmitter

    Prepare to Configure the Transmitter 1. Connect the ESC to the THRO channel on the receiver. 2. Connect the aileron, elevator, and rudder servos to their respective ports on the receiver. Motion RC Supplemental Guide for the Detrum GAVIN-6A Transmitter Page 3...
  • Page 6: Set Servo Direction

    3; if not, skip to step 4. 3. Use a small flathead screwdriver to slide the corresponding switch, such as the ELE switch, to the opposite position; the servo moves in the opposite direction. Motion RC Supplemental Guide for the Detrum GAVIN-6A Transmitter Page 4...
  • Page 7 1. Use a small flathead screwdriver to put the RATE switch in the LO or HI position. 2. Try flying the plane; if there isn’t enough control, set the RATE switch to HI or if there is too much control, set the switch to LO. Motion RC Supplemental Guide for the Detrum GAVIN-6A Transmitter Page 5...

Table of Contents