Page 2
Introduction Professional Stereo Brick Wall Audio Limiter The Newhank Level One is a small size, easy to use, low cost stereo limiter. The input control for left and right can be adjusted separately and the limiting levels is adjusted for left and right together.
Place the unit on a stable base or mount it in a stable rack. Safety requirements Always handle the unit with care. Only use a grounded socket outlet and a power cord with grounding plug to plug in the unit. www.newhank.com...
Pin connections and connectors The in and output connections of Newhank audio equipment are performed corresponding to international wiring standards for professional audio equipment. XLR: 1 = Ground / Shield 2 = Signal + 3 = Signal - XLR Female: XLR Male: www.newhank.com...
Front panel The front panel of the Level One contains all the controls and indicators and mechanical parts to lock the housing 1) CH1 and CH2 input level controls* 2) Green power on indication led 3) M6 screw with 2MM hole...
Rear panel At the rear panel of the Level One are all the connections provided. 1) 24 Volts power connector The included 24 volts power supply (24 volt DC) should be connected to this connector. Pay attention to the polarity when connecting the power supply.
Page 7
This chapter guides you through the setup process of a basic project with one Level One Limiter, an audio source device (mixing table) and a power amplifier. Overview of the Level One set up 1) Connecting the Level One fi...