1. Manuals
  2. Brands
  3. Unisound Manuals
  4. Speakers
  5. SPEAKER
  6. Installation manual

Unisound SPEAKER Installation Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
UNISOUND SPEAKER
1
2
1
2
3
4
3
4

Installation Manual

5
6
Dept.
Technical reference
Created by
Torstein Bakke
Document type
Title
SCP-XB1 Rev 1
5
6
7
8
Approved by
25.07.2017
Document status
DWG No.
Rev.
Date of issue
7
8
1
A
B
C
D
E
F
Sheet
1/1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SPEAKER and is the answer not in the manual?

Questions and answers

Summary of Contents for Unisound SPEAKER

  • Page 1: Installation Manual

    UNISOUND SPEAKER Dept. Technical reference Created by Approved by Torstein Bakke 25.07.2017 Document type Document status Title DWG No. SCP-XB1 Rev 1 Rev. Date of issue Sheet Installation Manual...
  • Page 2 • The speaker should not be placed in damp rooms, or rooms with excess of water or steam. WARNING: Contains small parts that may be a choking hazard. Not suitable for children under 3 years of age.

  • Page 3: Table Of Contents

    Introduction................................4 About..................................4 Unpacking..................................4 Recommended Tools..............................4 Speaker Wire Requirements............................4 Placement Guidelines..............................4 Installing the Speaker..............................5 Preparing the dropped ceiling and routing wires......................5 Connecting the speaker wire............................5 Installing the speaker..............................6 Connecting to Amplifier..............................6 Care and Maintenance..............................7 Troubleshooting................................7 Customer Service.................................7 Warranty..................................7 Technical Information..............................7 Dept.

  • Page 4: Introduction

    SHEET 1 OF 1 DO NOT SCALE DRAWING APPLICATION • Allow enough wire from the amplifier to the speaker, with a margin of at least 40 cm. • Please check your local building codes for the correct wire required for in-ceiling installation.

  • Page 5: Installing The Speaker

    Connecting the speaker wire Preparing the speaker 1. Pull out at least 40 cm of the speaker wire through the ceiling panel. Allow enough wire to connect to the speaker from where Remove any protection from the adhesive on the upper side of you are standing.

  • Page 6: Installing The Speaker

    Technical reference Created by Approved by Torstein Bakke 26.07.2017 Document type Document status 2. Tilt the speaker to such an angle that it goes through the Title DWG No. SCP-XB1 Rev 1 dropped ceiling frame. Rev. Date of issue Sheet NOTE: Illustration may not reflect actual conditions.

  • Page 7: Care And Maintenance

    CARE AND MAINTENANCE Troubleshooting Customer Service Problem What to do Unisound will go to great lengths to assist our customers. For further assistance, please contact Unisound customer service: No sound coming from speaker • Make sure you have power. www.unisound.no •...

Table of Contents