Subscribe to Our Youtube Channel
Related Manuals for Vivint SR1530
Summary of Contents for Vivint SR1530
- Page 1 SR1530 Outdoor Wireless AP Installation and User Guide Version 0.01 4931 NORTH 300 WEST PROVO, UT 84604 T: 801.377.9111 F: 801.377.4116...
- Page 2 SR1530 Installation and User Guide Page 2 Record of Changes Manual Version / Description Date 0.01 May 5, 2015 Preliminary version SR1530 Installation & User Guide Ver. 0.01...
- Page 3 Page 3 Notices This product contains software proprietary to Vivint and protected by US and International copyright law. Unauthorized reproduction or disclosure, in whole or in part, is strictly prohibited. The software and methods implemented in this product may be protected by US Patents:...
- Page 4 Caution, changes or modifications not expressly approved by Vivint could void the user’s authority to operate the equipment. RF Exposure: In order to comply with radio frequency (RF) exposure limits, the antennas for this product should be positioned no less than 20 cm from your body or nearby persons.
- Page 5 SR1530 Installation and User Guide Page 5 Copyright SR1530 Installation and User Guide, Version 0.01 Outdoor Wireless AP, © 2015. Vivint Wireless All right reserved. SR1530 Installation & User Guide Ver. 0.01...
-
Page 6: Table Of Contents
SR1530 Installation and User Guide Page 6 TABLE OF CONTENTS 1.0 INTRODUCTION 7 1.1.1 D 7 ATA RATES 1.1.2 R 7 ADIO LANNING 1.1.3 D 8 EVICE EIGHT 1.1.4 A 9 NTENNA OSITION AND OLARIZATION 1.1.5 R 9 ADIO NTERFERENCE 1.1.6 W 9 ... -
Page 7: Introduction
Under ideal deployment conditions (low line of sight, low interference, and low moisture content), the SR1530 AP can operate over a range of up to 1 km or provide a high-speed connection of 100 Mbps The range also depends on the type of antenna used. The maximum data rate for a link decreases as the operating range increases. -
Page 8: Device Height
SR1530 Installation and User Guide Page 8 If there are obstacles in the radio path, there may still be a radio link but the quality and strength of the signal would be affected. Calculating the maximum clearance from objects on a path is important as it directly affects the decision on antenna placement and height. -
Page 9: Antenna Position And Polarization
SR1530 Installation and User Guide Page 9 1.1.4 Antenna Position and Polarization Once the required antenna height has been determined, other factors affecting the precise position of the AP to be considered are given below. Ensure that there are no other radios/antennas within 2 m (6 ft) of the wireless router. These include other WLAN radios/antennas. -
Page 10: Ethernet Cabling
Operating in temperatures outside of this range may cause the unit to fail. Wind Velocity — The SR1530 can operate in winds up to 90 miles per hour and survive higher wind speeds up to 125 miles per hour. You must consider the known maximum wind velocity and direction at the site and be sure that any supporting structure, such as a pole, mast, or tower, is built to withstand this force. -
Page 11: Grounding
SR1530 Installation and User Guide Page 11 1.3 Grounding It is important that the wireless router, cables, and any supporting structures are properly grounded. The wireless router unit includes a grounding screw for attaching a ground wire. Be sure that grounding is available and that it meets local and national electrical codes. - Page 12 SR1530 Installation and User Guide Page 12 SR1530 The installation sequence is given below. SR1530 Installation & User Guide Ver. 0.01...
-
Page 13: System Setup
The SR1530 is setup by the Vivint professional installer/technician. 1.4 Administration 1.4.1 Adding Users & Changing Password The administration of the SR1530 is governed by the Vivint-NOC (Network Operations Center) Usage: adduser [OPTIONS] user_name Add an user Options: -h DIR... -
Page 14: Hardware Installation
The SR1530, is a wireless AP designed to be deployed outdoors, exposed to all elements (extreme heat or sun, rain, snow, ice, cold) and mounted on a wall, pole, or mast. The SR1530 is supplied complete with its own mounting hardware kit for attaching the unit to a 1-2.5”... -
Page 15: Testing Basic Link Operation
Seamless connectivity to wired LANs augment existing networks quickly and easily 3.2 Ethernet Compatibility The SR1530 Outdoor Wireless AP attaches to 10/100 Mbps Ethernet (FE) LAN segments that utilize 10Base-T/100Base-TX (twisted-pair) wiring. The device appears as an Ethernet node and performs a routing function by moving packets between the wired LAN and remote workstations on the wireless infrastructure.
Need help?
Do you have a question about the SR1530 and is the answer not in the manual?
Questions and answers