Polaris Scrambler 9922461 Owner's Manual page 65

Lubrication Guide
Check and lubricate all components at the intervals outlined in the Peri-
odic Maintenance Chart beginning on page 57. Items not listed in the
chart should be lubricated at the General Lubrication interval. See page
109 for the part numbers of Polaris products.
The a-arms and lower control arms are lubricated at the factory, and no
additional lubrication will be needed. However, if these components are
subjected to severe use, grease zerks have been provided for additional
lubrication at the user's discretion.
Item
Engine Oil
Brake Fluid
Drive Chain(s)
Transmission Oil
Demand Drive Fluid
(Front Gearcase)
Front Prop Shaft
Yoke
Front Hubs
Swing Arm
Bushings
Axle Housing
Ball Joint
Tie Rod Ends
Lube
PS-4 PLUS Performance
Synthetic 2W-50
DOT 4 Only
O-ring chain lube or SAE
80/90
AGL Synthetic Gearcase
Lube
Demand Drive LT
Premium Fluid
Premium U-Joint Lube
Premium Hub Lube
Premium All Season
Grease
Premium All Season
Grease
Premium All Season
Grease
MAINTENANCE
Method
See page 63.
See page 32.
Lubricate.
See page 68.
See page 70.
Grease fittings (3 pumps maximum)
every 500 miles (800 km), before long
periods of storage, or after pressure
washing or submerging.
Remove set screw in hubs. Rotate
wheels to 4 o'clock position. If lubricant
is not visible add more. Reinstall set
screw.
Locate fittings on swing arm and
grease with grease gun
Locate fitting on back side of struts and
grease with grease gun.
Lift boot, clean away dirt and grease,
apply fresh grease by hand and reas-
semble. Perform when suspension
action becomes stiff, or after washing.
61