Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for pureHeat GARAGE&PATIO
Summary of Contents for pureHeat GARAGE&PATIO
- Page 1 Owner’s Manual...
-
Page 3: Table Of Contents
Using pureHeat GARAGE & PATIO . . . . . . . . . . . . . . . . . . -
Page 4: About Pureheat Garage & Patio
ABOUT PUREHEAT GARAGE & PATIO Thank you for your purchase of pureHeat GARAGE & PATIO. This heater provides consistent warmth to outdoor spaces using carbon infrared heating technology, warming your friends and family directly instead of just heating the surrounding air. -
Page 5: Product Contents
PRODUCT CONTENTS 1 - Owner’s Manual 1 - Stand Base 1 - pureHeat GARAGE & PATIO Heater 3 - Cord Clips 1 - Remote Control 1 - Grille Guard (Batteries Not Included) 1 - Telescoping Stand Thread Diameter is denoted in mm by the first number. (i.e. M5*12 = 5mm diameter) Screw Length is denoted in mm by the second number. -
Page 6: Unit Diagram
UNIT DIAGRAM Control Panel Telescoping Lock Power Cord Top Post Middle Post Cord Clips Mounting Bracket Power Switch Bottom Post Stand Base Base Cover... -
Page 7: Important Instructions
IMPORTANT INSTRUCTIONS When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: • Read all instructions before using this heater. • This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. If provided, use handles when moving this heater. -
Page 8: Unit Setup - Floor Stand
UNIT SETUP - Floor Stand INSPECT THE UNIT FOR DAMAGE BEFORE SETUP OR USE. Begin by connecting the Bottom Post (Post with a Flat Base) to the Base, using the provided Four (4) M6*30 Screws. Slide the Base Cover over the connected post to cover the screws and then slide One (1) Large Cord Clip over the post. - Page 9 UNIT SETUP - Floor Stand Use Two (2) M6*14 Bolts and Two (2) Acorn Nuts to combine Top of Bracket 1 (Long End) to the Bottom of Bracket 2 (Short End) . Use Two (2) M6*38 Screws and Two (2) Wing Nuts to install the Front of Bracket 2 (Long End) to the rear of the Telescoping Post.
-
Page 10: Unit Setup - Wall/Ceiling Mount
UNIT SETUP - Wall/Ceiling Mount FOR YOUR SAFETY, READ ALL IMPORTANT INSTRUCTIONS (PAGE 7) AND USAGE (PAGE 13) BEFORE USING YOUR PUREHEAT PATIO. HEATER MUST BE MOUNTED HORIZONTALLY OR THE TIP OVER SAFETY SWITCH WILL ENGAGE AND THE UNIT WILL NOT OPERATE. -
Page 11: Control Panel/Remote Diagrams
CONTROL PANEL/REMOTE DIAGRAMS Control Panel Function ON LED Power Mode/Timer Hours Mode Button Timer Button MODE TIMER Remote Power Button Power Mode 1 Power Mode 2 (500W) (1000W) Timer Button Power Mode 3 (1500W) TIMER... - Page 12 READ ALL IMPORTANT INSTRUCTIONS (PAGE 5) BEFORE USING YOUR PUREHEAT GARAGE & PATIO. Power pureHeat GARAGE & PATIO starts in Standby Mode when first turned on. The unit has power but is not actively heating. To turn the unit on, toggle the Power Switch to “...
-
Page 13: Using Pureheat Garage & Patio
CLEANING TURN PUREHEAT GARAGE & PATIO OFF AND DISCONNECT FROM THE OUTLET BEFORE CLEANING. To extend the life of your pureHeat GARAGE & PATIO, perform regular cleanings with a damp cloth. Do not disassemble the unit; clean only the exterior. -
Page 14: Maintenance/Cleaning/Storage
LIMITED WARRANTY INFORMATION Your pureHeat GARAGE & PATIO (Product) is warranted to be free from all defects in material and workmanship in normal household use for a period of 3 Years from date of purchase. The warranty is granted only to the original purchaser. The warranty is subject to the following provisions: Any damages or malfunctions caused by negligence, abuse, or use not in accordance with the Product Owner’s Manual are not covered by this warranty. - Page 16 www.GreenTechEnv.com...
Need help?
Do you have a question about the GARAGE&PATIO and is the answer not in the manual?
Questions and answers