Fm Radio - Diasonic DMP-310 User Manual Manual

* The AUTO SEEK function facilitates tuning in to the radio channel.
Select RADIO, and hold down the FF key or REW key for about one second. The unit stops
seeking channels at the available channel.
The AUTO SEEK function may not be suitable for accurate tuning in the weak coverage area. In
this case, use the REW or FF key for fine tuning.
You can also use the MUTE, MONO or STEREO function for radio listening.
● Setting radio channel
Frequency channels are displayed on the LCD screen. Select the desired frequency with the FF
or REW key.
● Saving channels
① Frequency channels are displayed on the LCD screen. Select the desired frequency with the
FF or REW key.
② While listening to the radio, press the SRS button. The channel you are listening is memorized
in PRESET, and CHANNEL 01 blinks. Select the channel number (01-10) with the FF/REW key,
and press the SRS button. The channel is saved in CHANNEL 01. You can save up to 10
channels (CH1~10).
☞ Checking the saved channels.
In the FREQUENCY mode, hold down the SRS button. The unit enters into the PRESET mode,
and shows the saved channels and frequencies.
You can select a channel with the FF/REW key. If you press the MENU button in the PRESET
mode, you can select the frequency in the FREQUENCY mode.
● Recording radio
① Set the radio channel as explained in ①~② above.
② Press the REC button to record data. The recorded message is saved at the next index to the
last recording file.
You cannot check the recorded data while recording. You can check it in the RECORD range
after stopping recording.
To pause while recording, press the REC button. To resume recording, press the REC button
○ 3
again.
※ Note
• Noise may occur when recording radio in weak coverage or inside a building. Move to
strong coverage to acquire good sound quality.
• The earphone line works as an antenna. Extend the line to get good coverage.

FM Radio

17