RJE AquaGuard Owner's Manual

QUICK REFERENCE GUIDE

The following is a "quick reference" guide to operating your AquaGuard Pool Alarm System. Refer
to OPERATING THE AQUAGUARD SYSTEM on page 10 of this manual for detailed instructions to
operate, monitor and maintain the system.
Function
To turn the system on Enter your access code on the keypad.
•
The Detector Unit sounds 10 short
beeps, followed by one long beep,
indicating the system is "armed."
The red LED begins flashing.
To place the system in "SWIM" mode Enter your access code on the keypad.
•
The red LED on the Detector Unit
turns off. This indicates the system
is not armed.
To place the system in "ARMED" Press the OK button on the keypad two
mode times.
•
The Detector Unit sounds 10 short
beeps, followed by one long beep,
indicating the system is "armed."
The red LED begins flashing.
To place the system in "SERVICE" Enter __________ on the keypad.
mode (to allow for pool maintenance) •
The system is deactivated for 30
minutes.
To cancel an active alarm Press any key on the keypad.
To turn the system off for an Enter your access code followed by *99
extended period on the keypad.
At Detector Unit At Remote Unit
•
Not applicable
Press the OK button three times.
•
The green LED stops blinking; the
red LED blinks slowly.
Press the OK button two times,
•
The red LED stops blinking; the
green LED blinks slowly.
Not applicable
Press the OK button once.
Not applicable.
OWNER'S MANUAL
Revision A
RJE Technologies, Inc.
15375 Barranca Parkway, Suite B-107, Irvine, CA 92618
Ph: (877) 467-6627 • Fax: (949) 727-0070
www.aquaguardpoolalarm.com