KEC LSM104 Installation Information & Operating Instructions page 11

MENU BUTTON - OPERATIONS
(3) MTS
Your TV set incorporates an MTS(Multichannel Television Sound) decoder to receive stereo broad-
casts and any accompanying SAP (Second Audio Program), such as a bilingual broadcast.
The sound will be available :
1. Press the VOLUME+ button
To change the reception mode among
pressed, the mode will be changed as follows.
MENU
AUTOPROGRAM
CHANNEL LIST
STEREO
MTS
SAT
FM MODE
MONO
FM FREA
LANGUAGE : ENGLISH
MENU : NEXT +-:ENTER
In this mode, the STEREO SAP indicates that MTS mode is being broadcasted.
When the power is switched-on or channel is changed, the STEREO SAP symbol is automati-
cally displayed, depending on the current broadcast.
STEREO SAP
NOTES:
If the received signal is weak, noise may be heard.
In such a case, press VOLUME+ button to set the MONO mode for better sound reception.
If the received SAP signal is weak, the SAP will not be heard.
Even if both STEREO and SAP broadcasts are received, both broadcasts cannot be heard at a
time.
Transmission of CABLE TV signals differ from off-air TV broadcasts.
It is possible the TV sound(MTS) may not be received satisfactorily.
STEREO , SAP , MONO Whenever this button is
STEREO SAP MONO
2
TV
19
MENU BUTTON - OPERATIONS
(3) FM BROADCAST MODE & FM FREQUENCY
This function allows you to listen to the audio signal from the selected program source (TV, A/V1, A/V2, or
A/V3) on the vehicle's radio.
Procedure
1. Press the MENU button as many times as necessary to select "FM MODE".
2. Press the VOLUME + button as many times as necessary to set FM MODE as desired to:
"OFF", "MODE1" or "MODE2".
3. If "MODE1" was set in Step 2 above, press the MENU button again to select "FM FREQ.", then press
the VOLUME - / + buttons repeatedly to choose one of 4 preset FM Frequencies: 88.3MHz,
88.7MHz, 89.1MHz or 90.3MHz.
OR
MENU
AUTOPROGRAM
CHANNEL LIST
MTS:STEREO
FM MODE
FM FREQ
LANGUAGE
MENU : NEXT + -:SEL
If "MODE2" was set in Step 2 above, press the MENU button again to select "FM FREQ.", then press
/ + buttons to choose any FM Frequency from 88.3MHz to 95.0MHz in 0.1MHz
the VOLUME -
(100KHz) increments.
MENU
AUTOPROGRAM
CHANNEL LIST
MTS:STEREO
FM MODE
FM FREQ
LANGUAGE
MENU : NEXT + -:ADJ
4. Tune the vehicle's radio to the frequency chosen in Step 3 above.
It may be necessary to repeat Step 3, choosing a different frequency each time, before you are able
to receive a satisfactory signal. The best signal is usually obtained by choosing a frequency that is not
actively broadcasting in your area. Also note that better results may be obtained if the vehicle's anten-
na can be lowered independently.
MENU
AUTOPROGRAM
CHANNEL LIST
MTS:STEREO
FM MODE MODE 1
FM FREQ. 88.7MHz
LANGUAGE ENGLISH
MENU:NEXT +:ENTER
Example - Receiving Audio through the FM Radio at 88.7MHz.
NOTE
The FM Transmitter Antenna (Page 8#9) should be installed in the direction of the vehicle's main FM
Antenna.
Never adjust the LA01 coil on the FM Transmitter board. It was optimally adjusted at the factory.
MODE1
MODE2
OFF
88.3MHz
88.4MHz
95.0MHz
SCAN
FM
88.7MHz
SPEAKER
<CAR RADIO>
20