Giant T2007 User Manual page 10

2 x
/
If you want to communicate with the walkie talkies which are not
using a CTCSS/CDCSS code, you must select CTCSS/CDCSS
Scanning for a channel
Signals are searched for in the eight channels in a continuous
cycle. The
is detected, the channel scan stops. The Ready LED flashes ev-
ery second. Press the
tion. If the
after five seconds.
Start/End global channel scanning
of the output channel to 0 (zero). The scanning routine stops at
every channel on which a signal is received, regardless of the
code transmitted with the signal.
Start/End specific channel scanning
code for output channel to an individual value.
The scanning routine only stops when a signal is received on a
channel that matches the value set.
Operating the Walkie Talkies
,
An exception here is code 0 (zero). In the case of this
setting, all the calls on the set channel can be heard re-
gardless of the CTCSS/CDCSS code. To be able to
participate in the radio communication, it may be
necessary to set the necessary CTCSS/CDCSS code.
icon appears in the display. If an active channel
button is not pressed, channel scan resumes
The output channel is the channel which is set when the
channel scan is activated.
If a certain channel should be scanned fully during a
channel scan", the code must be set to 0 (zero)
for this channel.
Activate programming mode
Select the code and confirm it
button to enable radio communica-
Start/End channel scanning
Start/End channel scanning
8