Advertisement
Quick Links
NetKey Pre-Loaded Fiber Drawers
Part Numbers: NKFD1W6**DSC, NKFD1W12**DSC, NKFD1W12**DLC,
NKFD1W24**DLC
INSTALLATION INSTRUCTIONS
FS126
© Panduit Corp. 2016
NKFD1W6**DSC
NKFD1W12**DSC
NKFD1W12**DLC
NKFD1W24**DLC
Accessory Kit
(4) #12-24 x 1/2" Screws, (4) M6 Screws, (1) Fiber Caution Label, (1) Laser Warning Label, (2) Slack Spools and (1) PG11 Gland.
** Denotes adapter color/fiber type: EI (Electric Ivory/OM1 62.5/125µm), BL (Black/OM2 50/125µm), AQ (Aqua/OM3 10Gig 50/125µm),
or BU (Blue/OS1/OS2 9/125µm).
Knockouts for Blown Fiber Adapters
Knockouts for PG11 Glands
(4 places)
(2 places)
20mm Diameter
Knockouts for Rubber Grommets
(2 places)
30mm Diameter
Drawer Release
Latches
Provisions for Port
Identification Labeling
For Technical Support: www.panduit.com/resources/install_maintain.asp
Page 1 of 4
Advertisement
Summary of Contents for Panduit NKFD1W6**DSC
- Page 1 NetKey Pre-Loaded Fiber Drawers Part Numbers: NKFD1W6**DSC, NKFD1W12**DSC, NKFD1W12**DLC, NKFD1W24**DLC INSTALLATION INSTRUCTIONS FS126 © Panduit Corp. 2016 NKFD1W6**DSC NKFD1W12**DSC NKFD1W12**DLC NKFD1W24**DLC Accessory Kit (4) #12-24 x 1/2" Screws, (4) M6 Screws, (1) Fiber Caution Label, (1) Laser Warning Label, (2) Slack Spools and (1) PG11 Gland.
- Page 2 INSTALLATION INSTRUCTIONS FS126 © Panduit Corp. 2016 Mounting 6mm or #12-24 x 1/2" screws provided (4 places) Mount the enclosure to rack using four (4) 6mm or #12-24 x 1/2" screws provided. Drawer Opening and Removal Release latches Slide drawer forward...
- Page 3 INSTALLATION INSTRUCTIONS FS126 © Panduit Corp. 2016 Typical Cable Routing Options PG11 Gland with Pre-Terminated Trunk Grommet with Pre-Terminated Trunk or Field Termination or Field Termination Grommet with splicing using the PG11 Gland with splicing using the FSC24 Splice Sleeve Holder FSC24 Splice Sleeve Holder For Technical Support: www.panduit.com/resources/install_maintain.asp...
- Page 4 INSTALLATION INSTRUCTIONS FS126 © Panduit Corp. 2016 Typical Cable Routing Options (continued) FOSM installation: Place double stick tape underneath FOSM and locate the FOSM in the enclosure as shown. Grommet with splicing using the Blown Fiber with splicing using Fiber Optic Splice Module (FOSM)