Summary of Contents for Lindinger C-185
- Page 1 Modellbau Lindinger GmbH e-Mail: office@lindinger.at www.lindinger.at C-185 Manual Modellbau Lindinger GmbH e-Mail: office@lindinger.at www.lindinger.at...
-
Page 2: Safety Precautions
Modellbau Lindinger GmbH e-Mail: office@lindinger.at www.lindinger.at C-185 Manual C-185 Manual Foreword: Disclaimer: The new C185 has a lot of great features...it has an accurate scale 1.This RC model is not a toy.The owner/pilot is responsible for any appearance, great lines, simple assembly, stable but aerobatic flight damage to persons or property that results from the use of this product. -
Page 3: Technical Data
Modellbau Lindinger GmbH e-Mail: office@lindinger.at www.lindinger.at C-185 Manual C-185 Manual Technical Data: Assembly: Technical Data: Use of epoxy glue: Put equal amounts of part A and part B of the epoxy Standard version: Upgrade version glue onto a clean disposeable surface.Mix WELL and apply to the ●Wingspan: 1500MM... - Page 4 Modellbau Lindinger GmbH e-Mail: office@lindinger.at www.lindinger.at C-185 Manual C-185 Manual 4.Glue the fuselage and tail into place as pictures shown. 8.Install the elevator control rod as shown. 5. Glue the rudder and elevator servos into place as pictures shown. 9.Install the rudder and steering rods as shown: 6.Glue the elevator into place the same way, again, carefully checking alignment...
- Page 5 Modellbau Lindinger GmbH e-Mail: office@lindinger.at www.lindinger.at C-185 Manual C-185 Manual 12.Install the front landing gear and tighten into place using the provided wrench. 16.Install the nose carefully as shown. 13.Install the motor as shown, and fit it by using the provided screw.
- Page 6 Modellbau Lindinger GmbH e-Mail: office@lindinger.at www.lindinger.at C-185 Manual C-185 Manual 23.Fit and connect the battery cover as shown. 19.Install the wing support as picture shown. Upgrade Float installation: 20. Install your receiver and check the action of all controls. Be sure the throttle is in the off position before plugging in your battery to check controls.
- Page 7 Modellbau Lindinger GmbH e-Mail: office@lindinger.at www.lindinger.at C-185 Manual C-185 Manual 4. Fit the aluminum float struts as shown. 4).If the water is too smooth, the suction of the surface may keep the plane from taking off.In this case, circle around on the water to create some waves, then run across the waves to take off.
- Page 8 Modellbau Lindinger GmbH e-Mail: office@lindinger.at www.lindinger.at C-185 Manual C-185 Manual 3.Elevator and Rudder 4.landing gear 11.ESC. 12.Brushless Motor 14. 14.8V lipo charger 13. Lipo battery 5.Propeller 6.plastic parts: 7.Floats 8.Water rudder 9.9g servo 10.17g servo Modellbau Lindinger GmbH e-Mail: office@lindinger.at...
Need help?
Do you have a question about the C-185 and is the answer not in the manual?
Questions and answers