Install The Convertx Drivers - Plextor CONVERTX PX-M402U Installation And User Manual

Section 2. Installing Your ConvertX

Install the ConvertX Drivers

IMPORTANT NOTE: In the next steps of this procedure, you will be
installing driver files into your computer. You'll see the "Found New
Hardware" window more than once, and you may feel like you're seeing
the same dialog over and over again. This is normal. You don't need to
shut down or reboot your computer until all drivers have been installed.
1. You will use a USB cable to connect the ConvertX to your computer
as shown in Figure 10. Begin by making sure your computer is on.
Figure 10: 1) Make sure the computer is on, 2) make sure the Plextor
disc is inserted, 3) plug in the AC adapter, and then 4) connect the
ConvertX with the included USB cable.
2. Make sure the Plextor disc is in the computer's drive.
3. Connect the AC adapter to an electrical outlet and to your ConvertX.
4. Connect the USB cable from your ConvertX to the computer.
The drivers are installed automatically. When all drivers are installed,
your ConvertX is automatically recognized by the computer. (If you are
asked to reboot, remove the Plextor disc from the drive and restart your
computer.)
14
Plextor ConvertX PX-M402U Installation and Users Manual