Subaru LEGACY 2003 Service Manual page 11

D: ASSEMBLY
Assemble in the reverse order of disassembly. Do
the following:
NOTE:
When assembling, apply grease to the following
parts.
• Front and rear bracket sleeve bearing
• Armature shaft gear
• Outer periphery of plunger
• Mating surface of plunger and lever
• Gear shaft splines
• Mating surface of lever and clutch
• Ball at the armature shaft end
• Internal and planetary gears
1) Install overrunning clutch to shaft assembly.
2) Install stopper to shaft assembly in the following
order.
(1) Insert the ring into the shaft groove by lightly
tapping it with an appropriate tool (such as a fit
socket wrench).
(A)
(B)
(2) Install the stopper to ring using a press.
(A)
(B)
(A) Ring
(B) Stopper
3) When installing shaft assembly to front bracket,
be careful of the following.
STARTER
• Lever direction
• Internal gear position
• Packing position
SC-00067
4) When installing yoke to the front bracket, match
bolt hole.
SC-00068
SC(H4SO)-9
STARTING/CHARGING SYSTEMS
( A )
(A) Bolt hole
SC-00155
SC-00156
SC-00157
( A )
SC-00158