Related Manuals for Ingenico IMP300-MBCS
Summary of Contents for Ingenico IMP300-MBCS
- Page 1 Multi Charging Dock for iSMP IMP300-MBCS / IMP300-MBCW Ingenico – 28-32 Boulevard de Grenelle 75015 PARIS Tél. 33(0)1 58 01 80 00 - Fax 33 (0)1 58 01 91 35...
-
Page 2: Table Of Contents
5.1. Cleaning of the cradle _________________________________________________ 12 5.2. Transport and storage ________________________________________________ 12 5.3. Troubleshooting _____________________________________________________ 12 5.4. Environment (WEEE, Batteries and Packaging) ____________________________ 13 IMP300-MBCS / IMP300-MBCW 2/14 Copyright © 2013 Ingenico 900012498 R11 000 01/1307 All rights reserved... -
Page 3: Introduction
The IMP300-MBCS (296148325) and IMP300-MBCW (296148333, Bluetooth Model) accessories have been designed for iSMP Companion product do not attempt to use for any other use. -
Page 4: Unpacking
This User guide WARNING The power supply unit provided with your equipment is specially designed for Ingenico terminals. Do not use any other power supply. The use of a power supply with apparently similar voltage/current characteristics may damage your terminal. -
Page 5: Recommendations
Recommendations 3.1. Main Characteristics The main technical characteristics of the cradle Ingenico IMP300-MBCS are: Mass 740 g Dimensions (Lxlxh) 400x130x64mm Electrical mains network 100-240VAC / 50-60 Hz - Class I PSU Models Ingenico ref: 296202434 Operating conditions Ambient temperature from -10°C to +45°C Max relative humidity 85% at +45°C... -
Page 6: Security
Limited Power Sources (LPS) as stated in IEC60950-1:2005+A1:2010+A2:2013 et EN60950- 1:2006+A11:2009+A1:2010+A12:2011+A2:2013 standards Warning In such of misuse, all the certifications below and warranty for ISMP Companion and cradle would be voided IMP300-MBCS / IMP300-MBCW 6/14 Copyright © 2013 Ingenico 900012498 R11 000 01/1307 All rights reserved... -
Page 7: Standard Compliance Marking
The protection of the health and the safety of the user and any other person. The protection requirements with respect to electromagnetic compatibility. And complies with harmonised standards listed above. IMP300-MBCS / IMP300-MBCW 7/14 Copyright © 2013 Ingenico 900012498 R11 000 01/1307 All rights reserved... -
Page 8: Fcc & Ic Compliance
This device must be installed to provide a separation distance of at least 20cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter. IMP300-MBCS / IMP300-MBCW 8/14 Copyright © 2013 Ingenico 900012498 R11 000 01/1307... - Page 9 20cm avec l’utilisateur, et ne doit pas être installé à proximité ou être utilisé en conjonction avec une autre antenne ou un autre émetteur. CAUTION: The user is cautioned that any changes or modification not approved by INGENICO could void user’s authority to operate the equipment. ...
-
Page 10: Installation And Connection
Plug first the PSU unit to cradle before connecting the PSU to main power source. Plug the power jack and place the cable in the slot accordingly to back, right or left exit IMP300-MBCS / IMP300-MBCW 10/14 Copyright © 2013 Ingenico 900012498 R11 000 01/1307 All rights reserved... -
Page 11: Ismp Insertion
Before using iSMP Companion for the first time, you need to charge it for about 4 hours After that, you can charge the iSMP 3 hours to recharge the battery to full capacity IMP300-MBCS / IMP300-MBCW 11/14 Copyright © 2013 Ingenico... -
Page 12: Maintenance
Battery level is too low Check the PSU connections Check for iSMP positioning into the cradle Check for electrical power network IMP300-MBCS / IMP300-MBCW 12/14 Copyright © 2013 Ingenico 900012498 R11 000 01/1307 All rights reserved... -
Page 13: Environment (Weee, Batteries And Packaging)
The associated symbol means that WEEE and waste batteries must not be thrown away but collected separately and recycled. Ingenico ensures that efficient collection and recycling schemes are set-up for WEEE and batteries according to the local regulation of your country. Please contact your retailers for more detailed information about the compliance solution in place for disposing of your old product and used batteries. - Page 14 INGENICO. Moreover, nobody is authorized to place this document at the disposal of any third party without the prior written permission of INGENICO. If such permission is granted, it will be subject to the condition that the recipient ensures that any other recipient of this document, or information contained therein, is held responsible to INGENICO for the confidentiality of that information.
Need help?
Do you have a question about the IMP300-MBCS and is the answer not in the manual?
Questions and answers