Table of Contents
Advertisement
Speedway Revolution Installation and Operations Guide
Products Covered by this Guide
This guide pertains to readers that have the following part numbers:
Speedway R220 (FCC): IPJ-REV-R220-USA1M1
Speedway R420 (FCC): IPJ-REV-R420-USA1M1
Federal Communications Commission (FCC) Compliance
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interfer-
ence in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio com-
munications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turn-
ing the equipment off and on, the user is encouraged to try to correct the interference by one or more of the fol-
lowing measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Consult the dealer or a qualified radio/TV technician for assistance.
Caution
Changes to this product or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate per FCC Part 15.
Industry Canada (IC) Compliance
Operation is subject to the following two conditions: (1) this device may not cause interference and (2) this
device must accept any interference, including interference that may cause undesired operation of the device.
This device has been designed to operate with the antenna(s) listed on page 20 that have a maximum gain of 6
dB. Antennas not included in this list or having a gain greater than 6 dB are strictly prohibited for use with this
device. The required antenna impedance is 50 ohms. To reduce potential radio interference to other users, the
antenna type and its gain should be so chosen that the equivalent isotropically radiated power (EIRP) is not
more than that permitted for successful communication. The term "IC:" before the radio certification number
only signifies that Industry of Canada technical specifications were met.
!
Before You Begin
Please read this document in its entirety before operating the Speedway/Revolution reader, as serious personal
Warning
injury or equipment damage may result from improper use. Unauthorized opening of the Speedway/Revolu-
tion reader enclosure voids the warranty.
To safeguard personnel, be sure to position all antenna(s) according to the specified requirements for your reg-
ulatory region. For details, see "Appendix A: Information Specific to Regions of Operation" on page 19.
Copyright © 2009, Impinj, Inc.
Advertisement
Table of Contents
