Table of Contents
Advertisement
CC Streams
Item
Source port filter
Connection priority
Reorder buffer size
Stream fail delay
Link loss alarm
timeout
Description
Can be used to filter incoming data traffic. With multiple signals
sent to the same IP address and destination port number, Source
port filter can be used to filter the input, that is - to accept only
data from the transmitting port specified here. The filter will not be
active if set to 0 (the default and recommended setting).
Parameter intended for use with MX Software Development Kit.
Used to reorder incoming packets.
Range: [0...10000] ms. Default: 300 ms. Timeout in ms before
going to NoStream state.
Range: [1...1000] s. Default: 10 s. Time in seconds before alarm
sent.
117
Advertisement
Table of Contents
