Atex - S-products MP 2-wire series Instruction Manual

NORMATIVE REFERENCE:
The transmitters Mp82710, Mp82710H, Mp88710, Mp88710H and plug-in display Mp82000D have an EC
Type examination certificate issued by DEKRA and have been approved to the standards mentioned on the
certificate of conformity (see page 10) and the EC-Type examiniation certificate DEKRA 11ATEX0105 X
(see page 11).
SPECIAL CONDITIONS FOR SAFE USE:
For electrical data and temperature data see EC-Type examination certificat e DEKRA 11ATEX0105 X
on page 11.
INSTALLATION REQUIREMENTS:
- ATEX approved equipment is only to be connected to a Zenerbarrier.
The Temperature Transmitter must be mounted in an enclosure providing a degree of ingress protection of at
least IP20 per EN 60529.
This enclosure must be in conformance with Clauses 4.3 and 4.4 of EN 50284, when the Temperature
Transmitter is mounted in an area where the use of category 1 G apparatus is required.
This enclosure must be in conformance with Clauses 7.3 and 8.1 of EN 50014, when the Temperature
Transmitter is mounted in an area where the use of category 2 G apparatus is required.
The mentioned Clauses describe how to avoid danger of ignition due to electrostatic charges.
- All transmitters Mp82000 and Mp88000 have an ingress protection of IP20.
This requires usage in a dry, clean and well controlled environment.
Mount the Mp82000 transmitter in a (DAN) head as described below..
- It is prefered to use twisted pair, shielded cable to connect the transmitter to its power supply in order to
obtain the best immunity to Electromagnetic signals. On the power supply side connect the shield to the
power supply's earthing point, on the transmitter side connect the shield to the grounded head
somewhere close to the transmitter.
Make sure the transmitter is firmly connected to the head.
S-Products B.V.
Nijverheidscentrum 26, NL-2761JP Zevenhuizen, The Netherlands,
S-Products Inc.
9919 Valley View Drive, Eden Prairie, MN 55344, USA, Tel: +1 952 426 0886, Fax: +1 952 595 5996
E-mail: info@s-products.com
1
6
2
5 4
Internet: www.s-products.com
MOUNTING in CONNECTION HEAD
1. Screw M4
2. Transmitter
3. Measuring insert plate
4. Ferrule
5. Spring
6. Notch
3
Tel: +31 180 633455 , Fax: +31 180 633644
Document No. Manual MP 2-wire.cdr - Issue 150616
Page 5