Summary of Contents for TELIKOU Systems TM-800
- Page 1 TELIKOU Intercom System TM-800 Main Station Instruction Manual © TELIKOU Systems All Rights Reserved...
- Page 2 TELIKOU TM-800 Eight Channel Main Station I. Introduction Thank you for choosing TELIKOU intercom product. TM-800 main station is suitable for television station, communication center, UB truck, live performance and any other environment which requires communication. We recommend you read through this manual to better understand the functions of TM-800。...
- Page 3 Pin 2 -- Mic. hot Pin 3—Earphone - Pin 4—Earphone + Pin 5 -- LED working light power supply (Only for TM-800/5) Mic Select Switch Set the Mic select switch to select whether the panel microphone or the headset microphone is active.
- Page 4 TELIKOU TM-800 Eight Channel Main Station Microphone Switch (TALK) Turn up or down the switch handle will send amplified microphone signal through intercom line. When the switch handle is turned to ON or PTT, the LED above will light. The switch position settings are as follow: The selected microphone is activated, the switch is self-locked.
- Page 5 15. Sidetone zero-adjusting The TM-800 uses full-duplex audio in which the talk and listen audio are sent and received on the same line. Thus, when you talk on a channel, you will also here your own voice back in the speaker or earphone.
- Page 6 TELIKOU TM-800 Eight Channel Main Station 3 Turn on the microphone on sub-station and belt packs one by one, and then adjust the Sidetone to satisfied level. 16. Program Listen Level Control This knob is used to adjust the volume level of background program level which heard from earphone and speaker.
- Page 7 TELIKOU TM-800 Eight Channel Main Station 22. Tone Alert Level Control When TM-800 receives external call signal, the internal buzzer will sent a hum to panel speaker and earphone. This knob adjusts the hum level. 23. Panel Mic Gain It is used to adjust panel microphone gain to achieve proper microphone output level. It does not affect headset microphone’s sensitivity.
- Page 8 The pinout of Announce Out is as follows: Pin 1 --- Common (Shield) Pin 2 --- +Audio Pin 3 --- -Audio IV. Installation and cable 1. Installation TM-800 main workstation adopts 19-inches 1U cabinet, and this workstation can be mounted on...
- Page 9 V Troubleshooting Problem: Power LED wink Cause 1: Direct short on the intercom channel Solution 1: Remove all the intercom cables from TM-800. Check each channel one by one, until find the short channel. Cause 2: Overload Solution 2: Decrease the amount of remote stations.
- Page 10 TELIKOU TM-800 Eight Channel Main Station Solution 2: Adjust sidetone again. Cause 3: Channel un-terminated. Solution 3: Set the TM-800 termination switch to the ON position. Cause 3: A headset cord is too long or jointing quality. Solution 3: Check headset cord Problem: Excessive crosstalk Cause 1: High DC resistance in ground return.
-
Page 11: Headset Microphone
TELIKOU TM-800 Eight Channel Main Station HEADSET MICROPHONE: Dynamic 200-600 ohm POWER SUPPLY: AC 90-260V, 50-60Hz, <45VA DIMENSION: 19” (W) x1.75” (H) x9.48” (D), 482mm x 44.5mm x 241mm WEIGHT: 2.6kg...
Need help?
Do you have a question about the TM-800 and is the answer not in the manual?
Questions and answers