Summary of Contents for Freaklabs FL-AT86RF212-DEV
- Page 1 FreakLabs Rapid Prototyping Platform 900 MHz 802.15.4 Radio Board FL-AT86RF212-DEV v1.1 User Guide v1.1A...
- Page 2 Document Revision History Date Description 2010-04-01 Document creation FL-AT86RF212-DEV v1.1 Page 1...
-
Page 3: Specifications
50 ohms so that there will be very little power loss on the incoming and outgoing data signals. Connectors The universal serial connector (USC) interface is standard for all of the FreakLabs development boards. The FL-AT86RF212-DEV board contains a peripheral-side universal serial connector. Universal Serial Connector Pinouts The FL-AT86RF212-DEV radio board supports the Universal Serial Connector (USC) v1.1. -
Page 4: Pin Description
GPIO/ GPIO/ SCLK MISO IRQ1 ADC1 CAPT GPIO VCC5 The specific pinout of the universal serial peripheral connector of the FL-AT86RF212-DEV board can be found below: USC Peripheral Connector (JP1) Description Description VCC3 FL-AT86RF212-DEV v1.1 FL-AT86RF212-DEV v1.1 Page 3 Page 3... - Page 5 SCLK Disclaimer The FL-AT86RF212-DEV board is NOT FCC approved. It is designed to comply with FCC Part 15 rules. However this board is not in a finished product form and is only intended for experi- mental and research/development purposes. If you wish to use this board in an actual product, you will need to attain certification with the appropriate local regulatory body for the complete system.
- Page 6 PWR_LED FL-AT86RF212-DEV v1.1 Page 5...
- Page 7 FL-AT86RF212-DEV v1.1 Page 6...
-
Page 8: Pcb Layout
PCB Layout PCB layout file order: 1. Assembly drawing 2. Top Layer 3. Bottom Layer 4. Silkscreen FL-AT86RF212-DEV v1.1 Page 7... -
Page 9: Bill Of Materials
Ferrite Bead, 0805 Various 10x2 Right angle header, male, 0.100” Taiyo Yuden HK1608-12NJ- 12 nH, 0603, high freq Various 220 ohms, 0805 Various 10 kohms, 0603 Atmel AT86RF212 900 MHz, 802.15.4 radio NX3225SA 16 MHz crystal, 15 ppm FL-AT86RF212-DEV v1.1 Page 8...
Need help?
Do you have a question about the FL-AT86RF212-DEV and is the answer not in the manual?
Questions and answers