TBProAudio GainRider 2 Manual

Advertisement

Quick Links

GainRider 2
Manual
by TBProAudio 2016
(C) TBProAudio 2016
Page 1 of 8

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the GainRider 2 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for TBProAudio GainRider 2

  • Page 1 GainRider 2 Manual by TBProAudio 2016 (C) TBProAudio 2016 Page 1 of 8...
  • Page 2 So, GainRider 2 gives you this flexibility and the full control over the riding process. Features: •...
  • Page 3: Minimum System Requirements

    • Win: 32/64 Bit VST, 32/64 Bit VST3, 32 Bit RTAS, 32/64 Bit AAX • OS X: 32/64 Bit VST, 32/64 Bit VST3, 32/64 Bit AU, 32 Bit RTAS, 32/64 Bit AAX • Tested with: Cockos Reaper, Steinberg Cubase/Nuendo/Wavelab 6, FL Studio 12.x (C) TBProAudio 2016 Page 3 of 8...
  • Page 4 Simple gain riding of a (vocal) track: Load GainRider 2 plugin into the insert-slot of your (vocal) track. Load "default" program, make sure that automation is set to "Idle" and mode is set to "INT". Let the DAW play and watch the display.
  • Page 5 1 - 22k Hz 5.2 Input Control Side chain GainRider 2 can use side-chain (VST3/RTAS/AAX/AU) or channel 3+4 (VST2) as control channel for the ride process. Input Mode: • INT (Internal): main signal is leveled towards target level. The blue curve shows the incoming signal, the red curve the outgoing signal.
  • Page 6 Enables synchronization with DAW start/stop, display is reset before play. Automation: Idle: no read or write of automation data. Write: writes automation data to DAW. Record parameter “Current Gain” Read: reads automation data from DAW. (C) TBProAudio 2016 Page 6 of 8...
  • Page 7 CntrlSig: On/Off (pre filtered) control signal SrcSig: On/Off (processed) source signal (= output signal) Gain: On/Off gain curve Ride: On/Off ride curve Screen: On/Off screen Reset: Reset content of display Pause: Freeze display (C) TBProAudio 2016 Page 7 of 8...
  • Page 8 7 Notes, tips and tricks VST2 "side-chaining" VST2 does not support implicitly side chaining. VST3 introduced it for the first time to VST plugin architecture. So in order to use GainRider 2 VST2 a DAW with highly flexible channel routing is required. 8 Conclusion So finally if you have any questions or suggestions just let us know.

Table of Contents