Installing/ Removing Alkaline Batteries (Optional Battery Case) - Kenwood NX-3000 series User Manual

instaLLinG/ reMovinG aLKaLine Batteries
(oPtionaL Battery Case)
◆ Do not install batteries in a hazardous environment where
sparks could cause an explosion.
◆ Never discard batteries in fire; extremely high temperatures can
cause batteries to explode.
◆ Do not short circuit the battery case terminals.
◆ Do not use rechargeable batteries.
note:
◆ If you do not plan to use the transceiver for a long period,
remove the batteries from the battery case.
◆ This battery case has been designed for transmitting at a
power of approximately 1 W (the low power setting on your
transceiver). If you want to transmit a stronger signal (using
the high power setting on your transceiver), use an optional
rechargeable battery pack.
1 To open the battery case, press
on the two tabs on the upper
rear of the case, then pull the
two halves apart.
2 Insert 6 AA (LR6) Alkaline
batteries into the battery case.
• Be sure to match the polarities
with those marked in the
bottom of the battery case.
3 Align the tabs of the cover with
the base, then push down on
the cover until it locks in place.
15