Table of Contents
Advertisement
INTERIOR EQUIPMENT
GARAGE DOOR OPENER
The garage door opener (
Transceiver) is manufactured under license from
R
HomeLink
and can be programmed to operate garage
doors, gates, entry doors, door locks, home lighting
systems, and security systems, etc.
(a) Programming the HomeLink
"
1
Indicator light
2
Buttons
R
The HomeLink
in your vehicle has 3 buttons and you can
store one program for each button.
To ensure correct programming into the HomeLink
new battery in the hand-held transmitter prior to programming.
98
The battery side of the hand-held transmitter must be pointed
away from the HomeLink
R
Universal
For Canadian users, follow the procedure in "Programming an
entrance gate/programming all devices in the Canadian
market".
1. Decide which of 3 HomeLink
2. Place your hand-held garage transmitter 25 to 75 mm (1 to
R
3 in.) away from the surface of the HomeLink
Keep the indicator light on the HomeLink
programming.
3. Simultaneously press and hold the hand-held garage
transmitter button along with the selected HomeLink
4. When the indicator light on the HomeLink
slow to a rapid flash after 20 seconds, you can release both
buttons.
5. Test the operation of the HomeLink
programmed button. If programming a garage door opener,
check to see if the garage door opens and closes.
If the garage door does not operate, identify if your garage
transmitter is of the "Rolling Code" type. Press and hold the
programmed HomeLink
rolling code feature if the indicator light (on the HomeLink
R
, install a
flashes rapidly and then remains lit after 2 seconds. If your
garage transmitter is the "Rolling Code" type, proceed to the
heading "Programming a rolling code system".
R
during the programming process.
R
buttons you want to program.
R
.
R
in view while
R
button.
R
changes from a
R
by pressing the newly
R
button. The garage door has the
R
)
Advertisement
Table of Contents
