Advertisement
Installation of other parts:
1. Find the appropriate place for camera mounting. e.g.: Drill a hole to install the flush mount camera.
2. Find an appropriate place in the cab to mount the monitor and speaker, or control box.
3. Control box should be placed in a clean and dry place.
Note: Monitor, speaker and control box are not designed to be weatherproof. Please keep these parts clean and dry.
Connection:
1. Please pay attention to the wire harness for connection between the proximity sensor kit and the back up system. Make sure that the
reverse trigger wire from monitor is connected to the reversing light.
2. Connect the 4 Pin Female jack to the monitor and 4 Pin Male plug for camera.
3. The control box should be connected to the wire harness for VIDEO IN & VIDEO OUT. The sensor output cables should be connected
in sequence.
4. The control box and camera are both powered by monitor which is powered by vehicle battery through the DC Wire.
Note: Leave the output signal cable from sensors unconnected for testing use.
5. Reference wiring diagram below.
Testing:
1. Switch the vehicle into reverse, reversing lights will turn on automatically.
2. Connect one output cable from sensor to the control box. The sensor will attempt to find an object standing within 1.5 meters to the
right/left or in front of the sensor.
3. Remove the sensor and connect others one by one for testing in the same way.
4. After testing is complete, connect all the sensors with the control box.
Notice: *Most problems that occur in the testing are usually caused by improper installation of the sensors.
Hints for Users:
1. While reversing, it is recommended to use the reversing sensor system. This device is intended to offer assistance when reversing;
however, safety while operating a vehicle is the responsibility of the driver. Make sure to keep the vehicle at proper speed and pay
attention to the surrounding conditions while reversing.
2. There may be improper reception, deviation and error in the reflected signal because of difference in material, angle or size of the
obstacle.
3. To turn on/off the voice warning for the system, the driver must have the vehicle turned off. Move the switch to the on/off position before
you power on the vehicle.
Speaker Switch
Camera Volume
Adjust
Audio Input
Video Output
Control Box
Sensors
Video Input
WIRING DIAGRAM
Camera
Speaker (optional)
Monitor
Page 3 of 5
Advertisement
