ELEKTROBOCK CZ PT22 Manual page 5

PROG (PROGRAMMING)
Setting the weekly program with up to 6 changes per day.
Press twice the " MENU " button, choose the PROG mode by turning the
" " button, and press the"
to be programmed is blinking on the display; choose one of the
options by turning the "
Mon-Fri, 6-7 = Sat-Sun or 1-7 =Mon-Sun) and press the "
confi rm. The 1st change time starts fl ashing; set the time by turning the
" " button and press the "
for this time by turning the "
to confi rm. The 2nd change time appears on the display. Proceed in the
same way as with the fi rst change setting. In this way, you can set up to
6 temperature changes per day. To return to the menu, press the
" ".button.
After changing the preset program, check whether all the changes made
conform to your requirements!
It is not necessary to apply all six changes in one day!
CONST (CONSTANTS)
Setting the control parameters.
Press twice the " MENU " button, choose the CONST mode by
turning the " " button, and press the "
(Czech language set by default)
1 CESKY
Language selection (CZ/PL/EN/DE).
Choose the language by turning the "
" " button to confi rm.
2 HYSTEREZE
The hysteresis can be set from 0,1 to 6°C.
teresis is 1 °C and the required temperature 20 °C, the thermostat
switches off at 20 °C and on again at 19 °C.
Set the value by turning he "
to confi rm.
TEST
3
We recommend you to use the test when you fi rst use the
thermostat!
After you turn the "
is switched on/off several times (the display shows the ON/OFF
message). Pressing the "
constant; to return to the main menu, press the "
4
VERSION (restoring the default settings)
Firmware version, informative parameter only.
If you press the "
message appears shortly on the LCD and the thermostat returns
to the default settings!
5
" button to confi rm. The number of days
" button (you can program day-by-day or 1-5 =
" button to confi rm. Set the temperature
" button and press again the "
" button and press the
(0.5°C set by default)
" button and press the "
" button, the test starts and the output relay
" button, you can view the next
" button long (for about 3 s), the RESET
" button to
" button
" button to confi rm.
Example: If the hys-
" button
" button.
PROGRAMMING
SELECT dAY
TIME CHANGES
CONSTANTS
ENGLISH
HYSTERESIS
VERSION