Table of Contents
Advertisement
3.2 Defaults Group
Step downwards to reach lower manual settings; change to desired value by turning
incremental encoder knob. Save changes to current preset by pressing knob for more
than 2 seconds. On "live" drawbar preset 0 (DrbL) any changes are always saved
temporarily and restored when returning from preset to "live" in main menu.
• TubeAmp Gain, sets volume of internal rotary tube amp simulation from 0 to
full (overdriven tube amp). This menu entry may be reached directly from main
menu by pressing encoder knob briefly. Amp will get into decent saturation on
increased swell amount and higher gain values as seen on 'real' amps.
Amount of distortion is controlled by swell pedal.
• Master Volume, sets final volume of all outputs. For best noise performance,
higher values are desirable.
• ToneTrimPot mimics TONE pot on simulated AO28 amp; well, a little bit more
on high values.
• Reverb Prgm selects one of 3 different reverb programs. For each program,
amount of reverb may be adjusted.
o Reverb Lvl 1 reverb amount of reverb program 1
o Reverb Lvl 2 reverb amount of reverb program 2
o Reverb Lvl 3 reverb amount of reverb program 3
These parameters are saved to power-on defaults when encoder knob is pressed
more than 2 seconds.
Advertisement
Table of Contents
