Summary of Contents for Foxtron SERInet
-
Page 1: User Manual
User manual version 1.0 SERInet converter RS485 / Ethernet power supply passive PoE or 9-32V communication indication on the serial line galvanic separation RS485 / ETH installation on the DIN rail (2 modules) Terminals RJ15 for RS485 www.foxtron.eu... - Page 2 SERInet is a converter from RS485 to Ethernet (TCP/IP). Converter is possible to be supplied passive PoE thanks to the Ethernet data cable or by power supply on the terminals. Technical specification RS485, Ethernet speed (ETH) 10/100M protocol (ETH) TCP/IP...
- Page 3 10Mbit it is on 100Mbit Sending of the data on RS485 blinking signalizes outgoing data on the serial line incoming communication on RS485 bus blinking signalizes incoming data to the serial line 100M passive PoE 9-32V www.foxtron.eu...
- Page 4 Terminals connection SERInet in variant „SERInet RJ“ has on the side two equal connectors RJ15 (another variant is „SERInet ST“ with six pin screw terminals). 100M PEXbus (RJ15) IN 9-32VDC – PEXbus (RJ15) passive PoE 9-32V designation description Ethernet, passive PoE power supply...
- Page 5 Setup Setup of the SERInet converter is done by web browser. To the address line input the IP address of the converter. In the factory settings the address is 192.168.1.241 If the address is unknown the converter can be found using DALIconfig program which is downloadable for free on the www.foxtron.eu...
- Page 6 100BT Half duplex – Ethernet speed 100Mbps 10BT Half duplex – Ethernet speed 10Mbps TCP setup for incoming connection Listen for incoming network turn on the possibility to connect to the SERInet connections converter number of port on which the SERInet waits on...
- Page 7 By pressing the button „Submit New Settings“ the selected settings are saved. Serial line basic setup is shown in the following picture. RS-485 Half Duplex – half duplex two wires RS485 Data Port Settings RS-485 Full Duplex – full duplex four wires RS485 www.foxtron.eu...
- Page 8 For change of password fill the User Name and twice new password. In the case that you do not want to use password leave the password fields blank. By pressing the button „Submit New Settings“ you save new password. www.foxtron.eu...
- Page 9 Power Express (PEX) In the case of using with Power Express system (PEX) it is suitable to insert the reduction on the RJ15 connector which is used for PEX bus by default. Recommended setup „ “ for PEX bus. CUSTOM PACKETIZATION www.foxtron.eu...
- Page 10 Dimensions (in mm) tel: +420 274 772 527 e-mail: info@foxtron.cz web: www.foxtron.eu www.foxtron.eu...
Need help?
Do you have a question about the SERInet and is the answer not in the manual?
Questions and answers