Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for ACDC BSS-00504S
- Page 1 Solar LED Matrix Lamp Kit User Manual & Product Specifications Model BSS-00504S...
- Page 2 Index Page1 General Information Page1 Storage Tips and Operating Environment Page2 Components Kit Page2 How Solar Home System Works Page3 Specifications Page3 Installation Page5 Electrical Connection Page7 Maintenance Page8 Trouble-shooting Guide Page9 Page9 Warranty Exemptions...
-
Page 3: General Information
General Information Dear Customer, Thank you for selecting ACDC Powerpack series product and thank you for your contribution to environmental protection! Please read the manual carefully and thoroughly before using. Please follow the installation instructions on pages 3-5 of this manual to ensure personal safety and satisfactory product operation. - Page 4 Components Kit Your system should include all the following components. If there is anything missing please contact the distributor you purchased the kit from to arrange replacement. LED Lamp(4pcs) PV Module Power Pack Screws & Bolt Manual (1pc) (1pc) (2sets) (1pc) Cable Kit Phone Charging Kit...
-
Page 5: Specifications
Specifications Value Parameters Normal Voltage Max. Charging Current/Load Current ≤1A ≤2mA Current Natural Loss STC Power Operating Voltage (Vmp) Solar Module Operating Current (Imp) 0.29A 21.6V Open-Circuit Voltage (Voc) Short-Circuit Current (Isc) 0.34A Battery Type Maintenance Free Lead-acid battery Battery 12V/5.0AH Capacity 12 Super Bright LED... - Page 6 High temperature will reduce the performance of module, lowering power output. Good ventilation can effectively reduce the effect of power loss due to excessive heat. Panels should be installed in a well ventilated location. The solar panels are water resistant but not waterproof. Do not submerge in water or expose the panel to a continual flow of water.
-
Page 7: Electrical Connection
Controller Installation Lamp Installation Hang the lamp based on requirements. Back View Mounting Hole The Power Pack and Knock two nails into the wall the lamps are which the PowerPack is going to be installed, with the distance designed for indoor of 100mm between the two nails. - Page 8 STEP2 Before initial use or non-use of two months, please charge the battery for more than 20 hours in sunny day. Charging DC socket for 12VDC PV module PV Module Charging Indicater (Yellow LED) AC Adaptor(Optional) AC Power Supply Warning: Yellow LED Mode: The Power Pack can be supplied with the AC adaptor with special ·...
-
Page 9: Maintenance
Maintenance ACDC’s Solar Powerpack are designed to be essentially maintenance free. In certain regions with extreme conditions, however, some level of maintenance is required to ensure the proper function of the lights. These regions are typically where there is a risk of dust, snow, or ice covering the solar panels and thus reducing the power of the lights. -
Page 10: Troubleshooting Guide
Trouble-shooting Guide Fault Phenomenon Probable Cause Solution The connectors are loose, The battery plug is in the and it causes the parts to jar, press it tight and then All functions of the battery fall off. plug it tight again. become invalid, and the The battery voltage is red light goes out. -
Page 11: Warranty Exemptions
What direction should I tilt the module? The solar panel's top surface is the area that generates electricity and thus it is this surface should be exposed to the sun to capture maximum light. The maximum light is captured when the panel surface is at 90° angle to the sun's rays.