Table of Contents
Advertisement
4. How S180 works for you?
l Start
Insert mobile SIM card(
Ø
Wiring connect the camera and other digital sensors (if have) to the main unit.
Ø
Connect the power supply, Switch ON.
Ø
If you had programmed your phone number on S180, it will send a status SMS to your phone once switch ON.
Ø
l Arm & Disarm
(Recommend) Connect one button on the ARM (A+ and GND) port, you can press the button, 20 seconds
Ø
delay the system will enter to Arm status and makes 3 confirming beeps. You can also repress it for Disarm.
The DIN8 zone especially for entrance purpose, the sensor on DIN8 zone triggered will delay 15 seconds alarm,
Ø
so you have 15 seconds to Disarm the system before alarming.
You can also use APP of send SMS command to Arm/Disarm the system.
Ø
l Alarm
When alarm raised, S180 sends alert SMS and MMS picture to your phone and make siren sound, you can
Ø
pick up the phone call to listen the onsite voice.
You can edit the DIN1~8's zone name, so you can receive the readable alarm SMS like "Smoke alarm!" or
Ø
"Water alarm!".
l Remote Control
You can use APP or send SMS commands to switch ON/OFF the relay remotely.
Ø
l Inquiry Photos
You can use APP or send SMS commands to ask S180 sending back 1~20 photos to your mobile phone.
Ø
l Power Monitoring
You will receive alert SMS when AC/DC power lost and recovery, when back up battery low power, S180
Ø
makes alarm beeps for reminding.
S 18 0 G S M M M S C a m e r a A la r m S y s t e m
) to the SIM Card slot.
GSM850/900/1800/1900MHz
Page 6 of 9 Ver 1.0
Advertisement
Table of Contents
