Lawn Mower Safety Warnings - Blaupunkt GX4000 Instruction Manual

ELECTRICAL SAFETY
Before use check the supply and extension cord for signs of damage or
aging. If the cord becomes damaged during use, disconnect the cord from
the supply immediately. Do not touch the cord before disconnecting the
supply. Do not use the product if the cord is damaged or worn.
If you need to use an extension cord ensure it is suitable for outdoor use
it before every use for damage, always uncoil it during use because coiled
cords can overheat. Damaged extension cords should not be repaired,
they should be replaced with an equivalent type.
Make sure the power cord is positioned so that it cannot be damaged by
the cutting means and will not be stepped on, tripped over or otherwise
subjected to damage or stress.
Never pick up or carry the product by the electric cable.
Never pull by the power cord to disconnect from the power supply.
Keep the power cord away from heat, oil and sharp edges.
Make sure voltage is correct for your product. A nameplate on the product
indicates the product's voltage. Never connect the product to an AC
Always ensure the cord from the handlebar to the mower body is never
trapped, pinched or otherwise damaged during assembly or handle
folding. Never apply power to the mower if this cable is damaged. Return
to authorised service centre for professional repair.

LAWN MOWER SAFETY WARNINGS

Before using, always visually inspect to ensure blades, blade bolts, and
cutter assembly are not worn or damaged.
Replace worn or damaged blades and bolts in sets to preserve balance.
The blade on the product is very sharp. Use extreme caution and wear
security.
Return to an authorised service centre to replace damaged or unreadable
labels.
Check all nuts, bolts, and screws at frequent intervals for proper tightness
to be sure the equipment is in safe working condition.
Check the grass box frequently for wear, holes or deterioration.
LAWN MOWER SAFETY WARNINGS
Replace worn or damaged parts before operating the product.
The mower must be started with the user behind the handlebars in the
operator safety zone. Never start the product if:
All four wheels are not on the ground
The grass discharge chute is exposed without being protected by either
the mulching plug and grass discharge chute cover or the grass box and
grass discharge chute cover.
Hands and feet of all persons are not clear of the cutting enclosure.
properly start and stop the product.
extremely dangerous.
Do not force the product. It will do the job better and safer at the speed for
which it was designed.
Stop the blade when crossing gravel surfaces.
Do not pull the product backward unless absolutely necessary. If you must
behind to avoid tripping or pulling the product over your feet.
Stop the motor and allow the blade to stop if the product has to be tilted
for transportation when crossing surfaces other than grass, and when
transporting the product to and from the area to be mowed.
Never use the product with defective guards or shields, or without safety
Do not tilt the product when switching on the motor or whilst the motor
is running. This exposes the blade and increases the probability of objects
being thrown.
Switch on the motor carefully according to instructions and keep hands
and feet away from cutting area. Do not put hands or feet near or under
rotating parts. Keep clear of the discharge opening at all times. Do not
start the product when standing in front of the discharge opening.
Never pick up or carry the product while it is running.
Stop the mower motor and disconnect from the power supply, make sure
that all moving parts have come to a complete stop for the below cases:
whenever you leave the product unattended (including disposal of grass
clippings).
3 4