Page 1
Rechargeable and waterproof ◎ Controller ◎ Features 1.100 levels of vibration. 2.100 levels of static(optional). 3.The levels can be altered by use of up & down button. 4.A tone button activates a tone on the receiver collar. 5.The system can be used for 1 or 2 receivers collar. POWER SAVING 6.The Receiver Collar will TURN OFF if is unused for 4 minutes.
Page 2
2. Charge the Receiver Collar After Plug the charger into a standard outlet., the red LED light inside the Collar Receiver will be lighted. Charge the Collar Receiver at least 6 hours for the first charge. After fully charged ,the red LED light will be turned off automatically.
Page 3
◎ How to Use the controller. ●After install the batteries of receiver collar, you will hear a sound “beep”, now press Y button of Controller within 5 seconds, you can hear a “beep” again that means paired successfully. If not, please release the batteries of receiver collar and install them once again, and try the above steps.
Page 4
●Press Y button, test bulb will flash, that means Shock function works, you can press the UP/DOWN button to adjust the intensity level. ◎ How to Test Static Shock Function (after encoding is completed) 1.Take out the test bulb from the package and put it on the Receiver collar’s contact points.
Page 5
4.Test the static shock function •Take out the test bulb from the package and wind its metal wire on the Receiver collar’s contact points. • Pressing the Mode button switch to Shock mode, confirm LCD display not to be 0 , and then press the UP/DOWN button to adjust the intensity level.
Page 6
◎ Package includes 1 x Remote 1 x Receiver Collar(1 for 1)/ 2 x Receiver Collar(1 for 2) 1 x Controller 1 x Belt (1 for 1) / 2 x Belt (1 for 2) 1 x Test Bulb Notes for use: 1.The lifetime of the batteries vary according as how often you use the product.
Page 7
§ 15.19 Labelling requirements. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.