SAFETY INSTRUCTION IMPORTANT SAFETY INSTRUCTIONS Read, follow and keep these instructions. Heed all warnings. Do not use this apparatus near water. Clean only with dry cloth. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
RIGHT PANEL 1. On the front panel, Remote sensor, status indicators 2. USB interface 3. USB interface 4. TF Card slot REAR PANEL 1. AV plughole 2. Interface, ETHERNET 3. Interface, HDMI. An interface contains both audio signal and video. 4.
REMOTE PRECAUTIONS ABOUT BATTERIES Improper use of batteries may cause corrosion or fluid leakage. Please observe the following instructions for the safe use of batteries. 1. Do not mistake the polarities of batteries 2. Never leave dead batteries in the remote control 3.
Page 5
. Enter Standby mode or program-watching state. .close or open sound. Inner circle. Operation confirmation Outer circle. Direction keys .Operation return . Home Page ≡. Enter menu. +/-. Adjust volume ►║. Play or pause program ...
PREPARATION OF REMOTE CONTROL Load the batteries to the groove of the remote control and then enable you to operate the native. 1. Open the lid. 2. Load the batteries and attend whether the anode and cathode of battery are corresponding to the polarity indicated on the remote controller. 3.
SYSTEM CONNECTION 1. SET UP- AV For this Basic Set Up use a one-three cable for the video connection and for the audio connection. 1.1. Prepare your equipment Make sure that your TV has VIDEO, AUDIO R, and AUDIO L input. Ensure that the power leads to both the TV and the Set Top Box are unplugged before you commence the set up procedure.
Page 8
Set Top Box. 1.4. Connect the power a. Plug the connector of an adaptor into the socket. b. Plug the DC12V power input into the plughole on the rear panel. c. Connect the power to your TV and turn it on, you are now ready to get started.
Page 9
2.4. Connect power… a. Plug the connector of an adaptor into the socket. b. Plug the DC12V power input into the plughole on the rear panel. c. Connect the power to your TV and turn it on, you are now ready to get started.
Page 10
This equipment must be installed and operated in accordance with provided instructions and the antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.
Page 11
HOME PAGE After connection, plug into the power, the STB enters its Home Page. Use directional keys to move cursor and press the inner circle (Confirm) on the remote to enter. Enter different column to watch different program. Use the +/- key to adjust volume, use the key to mute or open sound.
Need help?
Do you have a question about the IHO-2000 I and is the answer not in the manual?
Questions and answers