Advertisement
Table of Contents
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Pro Audio PAW6.1
- Page 1 PAW6.1 6.5" 17cm 8Ohm Midrange Bass Woofer Single 80w RMS Instruction manual...
- Page 2 Thank you for choosing Bassface. From the simplest connector to our top of the range amplifier - every element of these products has been designed to give you the best possible performance for your money. Please take the time to read these instructions carefully as they contain useful and important information.
- Page 3 This speaker comes equipped with Copper Shorting Rings installed inside the mechanism. This improves the impedance profile of the speaker, and gives better transient response. Compared to running without you may find that you need to use slightly increased gain levels on the amplifier.
- Page 4 Car Installation: Generally, separate full range/mid bass/mid range driver units are considered to be specialist products, in that they are supplied as raw driver units without crossover network. The intention is that the unit will be installed in conjunction with an existing crossover unit or active crossover and a pair of tweeters which you supply.
- Page 5 panel, lower the resonance and give the speaker something solid to kick against. When you install the amplification please ensure that you maintain the same phasing setup throughout your installation. So it’s either “stripe to positive” or “stripe to negative” right the way through.
- Page 6 PA Installation: When using PAW series in a Professional application ensure that the box design has been carefully thought out to offer the desired response character. You can refer to the TS parameters supplied on our website to obtain this information. Also please ensure that you pay attention to the impedance of the speaker and design the full system to impose load on your amplifier no less than the acceptable impedance.
Need help?
Do you have a question about the PAW6.1 and is the answer not in the manual?
Questions and answers