Samsung WA52M7750A series User Manual page 25

*
STEP 4 Leveling your washer
WA7700M_DC68-03774D-00_EN+CFR+MES.indb 25
A
A
NOTE
Connect the hose guide (A) within 3~5 in
(7.6~12.7 cm)* from the end of the drain
hose. If the drain hose is extended beyond
the end of the hose guide, mold or
microorganisms could spread inside the
washer.
NOTE
The drain hose can be installed to a 96
in (245 cm) maximum, but the draining
capability can be reduced at this height.
It can cause the washer to have an odor
because of remaining water in the drain
system.
NOTE
If the drain hose is installed below 39 in (99
cm), water can be drained in cycles due to a
siphon phenomenon. It causes the washer to
display "4C".
See if the washer is level by checking the
position of the tub:
1. Slide the washer into position.
2. Open the lid of the washer, and pour
the water into the tub to just below the
pulsator level.
NOTE
WA52M7750A* models have the Built-in
sink over the pulsator level. That's why the
level is not revealed. Open the Built-in sink
and check the level with eyes.
English 25
2016-12-13 1:21:28