Advertisement

Quick Links

A4
User guide

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the A4 and is the answer not in the manual?

Questions and answers

Summary of Contents for Ekahau A4

  • Page 1 User guide...
  • Page 2 Your use of the Ekahau software described in this user manual and its documentation are governed by the terms set forth in your license agreement. Your use of this Ekahau software contrary to the terms of this User Manual may void the warranty, if any, described in your license agreement.
  • Page 3: Table Of Contents

    2.2 Resetting to Factory Settings ................... 3 2.3 Firmware Update ..................... 3 2.4 Optimizing Battery Life ..................... 4 2.5 Turning off the A4 Tag ....................4 3 Technical specifications ....................5 3.1 General ........................5 3.2 Operating Ranges from an Access Point ..............5 3.3 Battery Replacement ....................
  • Page 5: Introduction

    Chapter 1. Introduction 1 Introduction The Ekahau A4 Wi-Fi tag is part of Ekahau RTLS (Ekahau Real-Time Location System) that consists of Ekahau Wi-Fi location tags, Ekahau RTLS Controller (ERC) software platform and Ekahau Vision end-user application. It is designed to be worn by patients, employees, children and other individuals, and it enables real-time visibility into a person’s exact location –...
  • Page 6: User Interface

    Chapter 1. Introduction 1.3 User Interface Figure 1.1. A4 user interface...
  • Page 7: Tag Operation

    2.2 Resetting to Factory Settings The Ekahau A4 tag can be reset to factory settings by using a button sequence as follows: Press and hold the White button until Left LED flashes orange. If the tag is busy tvvhis may take even 20 seconds.
  • Page 8: Optimizing Battery Life

    2.5 Turning off the A4 Tag The A4 tag can only be turned off by resetting the tag to factory settings which is explained in chapter Resetting to Factory Settings on page 3. To continue using the tag after resetting, you...
  • Page 9: Technical Specifications

    Chapter 3. Technical specifications 3 Technical specifications 3.1 General ● Outside Dimensions (mm): 45 x 55 x 19 ● Weight: 1.7 oz / 48 g with batteries ● Power: 2xCR2 3.0V Lithium (LiMnO2) batteries ● Two buttons with call button functionality ●...
  • Page 10: Care And Maintenance

    Replace both batteries at the same time ● Use only 3.0V, CR2 size batteries ● Ekahau recommends batteries from Duracell, Maxell, Sanyo or Varta After batteries have been replaced close the back cover, replace and tighten the screws. 3.4 Care and Maintenance ●...
  • Page 11: Certifications

    Chapter 4. Certifications 4 Certifications 4.1 FCC Rules This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
  • Page 12 Chapter 4. Certifications...
  • Page 13: Limited Warranty

    Accident, fire, power failure, power surge, or other hazard. Otherwise, the Tags are sold AS IS. In no event does Ekahau warrant that the Tags are error free or that end user will be able to operate the Tags without problems or interruptions.
  • Page 14 Chapter 5. Limited Warranty...
  • Page 15: Disposing

    6 Disposing Note The Ekahau A4 Wi-Fi tag is non-recyclable. To dispose the tag, send it to a company that is capable of handling electrinical waste. Alternatively, you can send the tag back to Ekahau who will dispose it for you.
  • Page 16 Chapter 6. Disposing...

Table of Contents