Table of Contents
Advertisement
U
S
E
R
DEVICE RECHARGING
The tracker is recharged by using a battery charging
pad, compatible with the Qi wireless charging stan-
dard. We strongly recommend usage of the supplied
charging pad and the power adapter.
The charging pad must be plugged in and switched
on. Immediately after insertion into the power socket
the LED light should give one short blue flash.
Place the tracker onto the pad with the magnets fa-
cing upwards. Correct charging is signalized by a
blue LED. If, during charging of tracker devices
without magnets, the LED is not lit up, please
turn the tracker over, otherwise the tracker will
not be charged.
If the tracker batteries are completely discharged it
will take around 4 hours for them to be completely
recharged again.
M
A
N
U
A
TICK
L
Magnetic GPS tracker
Possible charging pad LED signals:
Solid blue LED
Flashing blue LED – charging has stopped due to
Solid green LED
Troubleshooting of charging errors
• Remove the tracker from the charging pad, wait
5 seconds and put it on the pad again. Make sure
the position on the pad is slightly different from
the previous spot and close to the centre of the
charging pad.
• If the LED starts flashing again, please place
a piece of solid plastic or piece of paper up to
3 mm thick between the bottom of the tracker and
the top of the charging pad. Do not use any
metallic object.
• If the blue LED does not light up when the device
is put on the charging pad, try a different charging
pad and/or switch the power adapter. It is strongly
recommended to use the supplied parts only.
– correct charging in progress
error (please see the trouble
shooting guide)
– charging has stopped, the
batteries are full
4
Advertisement
Table of Contents
