Norelco ULTRASWITCH 100 User Manual page 2

REGISTRATION
The Canadian Department of Communications label identifies certified
equipment. This certification means that the equipment meets certain
telecommunications network protective, operational and safety requirements.
The Department does not guarantee the equipment will operate to the user's
satisfaction.
Before installing this equipment, user should ensure that it is permissible to be
connected to the facilities of the local telecommunication company. The
equipment must also be installed using an acceptable method of connection.
In some cases, the company's inside writing associated with a single line
individual service may be extended by means of a certified connector
assembly (telephone extension cord). The customer should be aware that
compliance with the above conditions may not prevent degradation of service
in some situation.
Repairs to certified equipment should be made by an authorized Canadian
maintenance facility designated by the supplier. Any repairs to alterations
made by the user to this equipment, or equipment malfunctions, may give the
telecommunications company cause to request the user to disconnect the
equipment.
Users should ensure for their own protection that the electrical ground
connections of the power utility, telephone lines and internal metallic water
pipe system, if present, are connected together. This precaution may be
particularly important in rural areas.
Caution: Users should not attempt to make such connections themselves, but
should contact the appropriate electric inspection authority, or electrician, as
appropriate.
The Load Number (LN) assigned to each terminal device denotes the
percentage of total load to be connected to a telephone loop which is used by
the device, to prevent overloading. The termination on a loop may consist of
any combination of devices subject only to the requirement that the total of
the Load Numbers of all the devices does not exceed 100.