Download Print this page

Regular Maintenance - Novatech ST-400A Operation & Maintenance Manual

Xenon flasher

Advertisement

12
Battery Life
(Days)
(ON at night
9
OFF during
daylight)
6
3
2.0
2.5
Range in Nautical Miles
Figure 2. ST-400A — Battery Life Estimates "Double Burst Flash"
For single
burst
setting,
increase
battery life
by approx.
30%
3.0
3.5
4.0
6
ST-400A
MAINTENANCE
There are no user repairable parts in the ST-400A, return to the factory for
repairs.

REGULAR MAINTENANCE

Rinse thoroughly with fresh water after every use
Always remove batteries when not in use
Always use fresh batteries
Protect "O" ring surface from damage
Replace worn or damaged "O" rings
Keep batteries and electronics dry
"O" RING FACTS
"O" rings don't last forever; two to five years is a conservative estimate.
The main problem with "O" rings is that over time they can take a "set".
They lose their original round shape and they become slightly flattened
resulting in less squish. Reduced squish can lead to a water leak near the
surface. The best way to prevent a problem is to service the "O" rings
before every deployment.
Some of the main factors that can cause a "set" are:
High storage temperature (exceeding 40ºC) over time will cause the rubber
to harden
Exposure to sunlight and ozone will cause the "O" ring to deteriorate and
stiffen
Temperature does not have to be that cold for an "O" ring to lose a great
deal of its flexibility. At 4ºC, an "O" ring has stiffened significantly.
"O" rings must be lightly lubricated with silicone- based grease. We rec-
ommend "Parker Super O Lube"
A typical seal failure results in a very small amount of water, not a flooded
case. Most seal failures occur near the surface
The "O" ring becomes less flexible as the rubber ages
If you are operating or storing at low temperature, it makes it even more im-
portant to service the "O" ring regularly
ST-400A
7

Advertisement

loading