Advertisement
Advertisement
Table of Contents
Related Manuals for Assault SPLT.1
Summary of Contents for Assault SPLT.1
- Page 1 SPLT.1 4" Inch 98mm 4Ohm Titanium Bullet Tweeter Pair 300w RMS Instruction manual...
- Page 2 Thank you for choosing Bassface. From the simplest connector to our top of the range amplifier - every element of these products has been designed to give you the best possible performance for your money. Please take the time to read these instructions carefully as they contain useful and important information.
- Page 3 The SPLT.1 Tweeter kit now comes with pre installed 3.3uf capactitors, providing an effective and very safe crossover and protection from low frequency damage which has previously been a problem due to inexperienced installers making mistakes! This will increase power handling but reduce output, however, so it is acceptable to remove these and to install the drivers in a active configuration, or to replace them with capacitors of a...
- Page 4 Begin by selecting a suitable location for the installation of the tweeters. When you plan, try to keep the distance between the left tweeter and your left ear and the right tweeter and your right ear as similar as possible. This will improve the sound imaging. There is a trade off, however, as installing the high frequency speakers lower down will also tend to lower the level of the edges of the sound stage.
- Page 5 doubling up on high frequency load so always listen carefully for distortion during setup and make sure you understand the electrical limitations of the equipment. So the important bits are: * Don’t put a passive crossover box or capacitor or anything else inside the door of the vehicle between the waterproof membrane and the metal door on the “wet”...
Need help?
Do you have a question about the SPLT.1 and is the answer not in the manual?
Questions and answers