Ddc Instructions - Philips 150S7 Service Manual

15" LCD Color Monitor
13. DDC Instruction
General
DDC Data Re-programming
In case the main EEPROM with Software DDC which store all factory settings were replaced because a defect,
repaired monitor' the serial numbers have to be re-programmed.
It is advised to re- soldered the main EEPROM with Software DDC from the old board onto the new board if circuit
board have been replaced, in this case the DDC data does not need to be re-programmed.
Additional information Additional information about DDC (Display Data Channel) may be obtained from Video
Electronics Standards Association (VESA). Extended Display Identification Data (EDID) information may be also
obtained from VESA.
System and equipment requirements
1. An i486 (or above) personal computer or compatible.
2. Microsoft operation system Windows 95/98/2000/XP.
3. "WinDDC, PORT95NT, config, W, CHECK, Philips 170S EDID" program.
4. Software DDC Alignment kits
The kit contents:
a. DDC Board x1
b. Printer cablex1
c. D-Sub cable x1
d. 12V DC power source
(1). Install software
You must install the
(Take 170S model for example)
at the first. The processing as follows:
50
150S7