Diagrams; Circuit Boards Location; Waveforms - Sony TA-AV571 Service Manual

SECTION 3

DIAGRAMS

3-1. CIRCUIT BOARDS LOCATION

T-1 board
T-2 board
H.P board
DISPLAY board
POWER board
REAR SP board
MAIN board
VR board
— 5 —
THIS NOTE IS COMMON FOR PRINTED WIRING BOARDS
AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is printed in each
block.)
NOTE
• : parts extracted from the component side.
• : Pattern from the side which enable seeing.
NOTE
• All capacitors are in µF unless otherwise noted. pF : µµF
50WV or less are not indicated except for electrolytics and
tantalums.
• All resistors are in Ω and 1/4W or less unless otherwise speci-
fied.
• ¢ : internal component.
• : nonflammable resistor.
• : panel designation.
Note:
The components identi-fied by mark ! or dotted line with mark
! are critical for safety.
Replace only with part number specified.
• B+ : B+ Line
• B– : B– Line
• Voltage and waveforms are dc with respect to ground under no-
signal conditions.
no mark : STOP
• Voltages are taken with a VOM (Input impedance 10MΩ).
Voltage variations may be noted due to normal production toler-
ances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal production toler-
ances.
• Circled numbers refer to waveforms.
• Signal path.
: FM

3-2. WAVEFORMS

MAIN SECTION
1
5.2Vp-p
8MHz
IC202 @¢
PANEL SECTION
2
4.2Vp-p
5MHz
IC401 #¢ X1
— 6 — — 5 —