All company names, brand names, and product names referred to in this manual are registered or unregistered trademarks of their respective holders and are, as such, protected by national and international law. page 6 ADL Embedded Solutions ADLE3800SEC...
Solutions will be covered, provided a written claim for service under warranty is received by ADL Embedded Solutions no less then 30 days prior to the end of the warranty period of within 30 days of discovery of the defect – whichever comes first. Warranty coverage is contingent upon proper handling and operation of the product.
Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. page 8 ADL Embedded Solutions ADLE3800SEC...
IO extension. An RGB LED signals the state of powercontroller. Input voltage is 24V. Even though the ADLE3800SEC is designed in an extremely compact and small format, it offers the full motherboard functionality. Input-...
16V - 30V input voltage range Overvoltage- and undervoltage protection Reverse voltage protection Not galvanically isolated Format 75 mm x 75 mm The feature list specifies all suitable CPUs. Their actual availability is OTICE manufacturer-specific. page 10 ADL Embedded Solutions ADLE3800SEC...
The ADLE3800SEC is equipped with four fixed DRAM memory modules. Depending on the product variant, there are different memory modules in use, as there are a DDR3 variant with 2GByte and another one with 4GByte memory. The ADLE3800SEC supports a maximum frequency of 1333MHz, depending on the CPU type.
Chapter: Connectors 4 Connectors This section describes all the connectors found on the ADLE3800SEC. Please consider the requirements on the cabling! OTICE For most interfaces, the cables must meet certain requirements. For instance, USB 2.0 requires twisted and shielded cables to reliably maintain full speed data rates.
A range of standard connectors are available: You can connect displays, USB, LAN etc. The following connectors are located on the front panel of the ADLE3800SEC. 4.2.1 Power Supply The power supply of the ADLE3800SEC is realized via a 2x2pin connector (P20THR-1787014). The main 24V power lines are assigned to pin 3. Manufacturer...
USBX# minus channel USBX USBX plus channel USBX ground Pinout USB3.0 connector for channel X: Name Description 5 volt for USBX USBX# Minus channel USBX USBX Plus channel USBX ground StdA_SSRX- SuperSpeed Receiver - page 16 ADL Embedded Solutions ADLE3800SEC...
LAN1 channel 2 minus LAN1-3 LAN1 channel 3 plus LAN1-3# LAN1 channel 3 minus The LEDs show activity and speed of data transfer: Mbit/s flashing at data transfer permanent 1000 green green green orange green page 18 ADL Embedded Solutions ADLE3800SEC...
4.3 Memory and internal connectors 4.3.1 DRAM Memory The ADLE3800SEC is equipped with four fixed DRAM memory modules DDR3-667. Depending on the hardware variant, there are two different memory modules in use, which are one DDR3 variant with 2GByte and one DDR3L variant with 4GByte memory.
4.3.2 M.2 2242 (Keying B) The ADLE3800SEC is equipped with a further M.2 socket, in which M.2-2242 cards (keying B) can be inserted. The socket leads SATA signals (up to 3 Gb/s) through, and therefore enables the use of an M.2 SSD card.
Page 21
OTICE 'Description'. Items marked with (*) are optional ressources. If you use an add-in card, which is not or not fully supported, the BIOS will display an error message. ADL Embedded Solutions ADLE3800SEC page 21...
Ground 3.3V Power supply 3,3V Switching to HDMI By default, the interface offers DisplayPort signals. According to OTICE DisplayPort specification 1.1., the ADLE3800SEC will automatically switch to HDMI, when using a level shifter cable. page 22 ADL Embedded Solutions ADLE3800SEC...
Chapter: Connectors 4.3.4 BAseCon140 Connector With the BAseCon140 connector the ADLE3800SEC provides a flexible and uncomplicated add-on of additional IO interfaces. The BAseCon140 connector offers up to 8 PCIe lanes, from which 4 can be muxed with SATA2.0 (3G) and the other 4 can be muxed with USB3.0 signals. It also leads through DisplayPort-, HSIC-, SMBus- and 1Wire-signals.
Page 25
'Description'. Items marked with (*) are optional ressources. If you use an add-in card, which is not or not fully supported, the BIOS will display an error message. ADL Embedded Solutions ADLE3800SEC page 25...
Chapter: Connectors Memory and internal connectors 4.3.5 External Battery In order to supply the ADLE3800SEC in case of a powerfail, it can be plugged into an external RTC battery via a 2pin connector. The maximum battery voltage is 3.3V. Manufacturer...
A 3-pin connector is available for controlling and monitoring an external fan (5 volt). For the monitoring the fan must provide a corresponding speed signal. Manufacturer Description Mating Connector BM03B-SRSS-TB(LF)(SN) z.B. JST SHR-03V-S Name Description FANON Control signal FAN Power supply 5V regulated FANCTRL Monitoring signal FAN ADL Embedded Solutions ADLE3800SEC page 27...
Chapter: Connectors LED Signaling 4.4 LED Signaling 4.4.1 RGB LED The ADLE3800SEC has a tricolor LED, which signals status messages by using different colors and flash intervals. Color Interval Meaning solid Invalid system state White once Powerfail Cyan solid Reserved...
LED Signaling Chapter: Connectors 4.4.2 Harddisk-LED An additional RGB LED signals the harddisk activity. Colours Interval State intermittent active ADL Embedded Solutions ADLE3800SEC page 29...
Chapter: Connectors LED Signaling 4.4.3 TwinCAT-LED The TwinCAT activity is signaled through a further RGB LED: Colour Interval State Green permanent TwinCAT Run Mode Blue permanent TwinCAT Config Mode permanent TwinCAT Stop page 30 ADL Embedded Solutions ADLE3800SEC...
They do not represent the recommended settings or the default settings. Determination of the appropriate settings is dependent upon the particular application scenario in which the board is used. ADL Embedded Solutions ADLE3800SEC page 31...
Options: none BayTrail SoC Options: none Total Memory Options: none System Date Options: The system date can be adjusted here. System Time Options: The system time can be adjusted here. page 32 ADL Embedded Solutions ADLE3800SEC...
Sub menu: see "Miscellaneous Configuration" (page 42) Network Stack Sub menu: see "Network Stack" (page 43) Power Controller Options Sub menu: see "Power Controller Options" (page 44) CSM Configuration Sub menu: see "CSM Configuration" (page 45) ADL Embedded Solutions ADLE3800SEC page 33...
Page 34
Security Configuration Sub menu: see "Security Configuration" (page 49) Intel(R) Gigabit Network Connection Sub menu: see "Intel(R) I210 Gigabit Network Connection" (page 50) Driver Health Sub menu: see "Driver Health" (page 52) page 34 ADL Embedded Solutions ADLE3800SEC...
└─────────────────────────────────────────────────────────────────┴────────────────────────────────┘ Version 2.17.1249. Copyright (C) 2016 American Megatrends, Inc. CPU C state Report Options: Disabled / Enabled Max CPU C-state Options: C7 / C6 / C1 S0ix Options: Disabled / Enabled page 40 ADL Embedded Solutions ADLE3800SEC...
Options: Do not launch / UEFI only / Legacy only Video Options: Do not launch / UEFI only / Legacy only Other PCI devices Options: Do not launch / UEFI / Legacy ADL Embedded Solutions ADLE3800SEC page 45...
Options: none Chip Type Options: none PCI Device ID Options: none PCI Address Options: none Link Status Options: none MAC Address Options: none Virtual MAC Address Options: none page 50 ADL Embedded Solutions ADLE3800SEC...
Page 51
Version 2.17.1249. Copyright (C) 2016 American Megatrends, Inc. Link Speed Options: Auto Negotiated / 10Mbps Half / 10Mbps full / 100Mbps Half / 100Mbps Full Wake On LAN Options: Enabled / Disabled ADL Embedded Solutions ADLE3800SEC page 51...
│ │ │ │ │ └─────────────────────────────────────────────────────────────────┴────────────────────────────────┘ Version 2.17.1249. Copyright (C) 2016 American Megatrends, Inc. North Bridge Sub menu: see "North Bridge" (page 55) South Bridge Sub menu: see "South Bridge" (page 59) page 54 ADL Embedded Solutions ADLE3800SEC...
Restore AC Power Loss Options: Power Off / Power On / Last State Onboard Gigabit LAN X Options: Enabled / Disabled M.2-PCIe Configuration Pins Options: none M.2-SATA Configuration Pins Options: none ADL Embedded Solutions ADLE3800SEC page 59...
Page 61
│ └─────────────────────────────────────────────────────────────────┴────────────────────────────────┘ Version 2.17.1249. Copyright (C) 2016 American Megatrends, Inc. USB Mode Options: EHCI / XHCI USB Per Port Control Options: Enabled / Disabled USB Port x Options: Disabled / Enabled ADL Embedded Solutions ADLE3800SEC page 61...
Page 62
│ │ │ │ │ │ │ │ │ │ │ │ │ │ │ │ └─────────────────────────────────────────────────────────────────┴────────────────────────────────┘ Version 2.17.1249. Copyright (C) 2016 American Megatrends, Inc. PCIe Port x is assigned to Options: none page 62 ADL Embedded Solutions ADLE3800SEC...
BIOS file which was issued for the exact board and exact board revision that you wish to update. If you try to update the BIOS using the wrong file the board will not start up again. ADL Embedded Solutions ADLE3800SEC page 69...
PCB: Die Center Chapter: Mechanical Drawings 6.2 PCB: Die Center 9.73 CPU DIE Center and size 10.49 27.55 43.56 30.61 26.56 15.14 15.14 41.71 dimension=mm H1-H3 =1,8mm x 3mm ADL Embedded Solutions ADLE3800SEC page 71...
5 up to 9Hz, 3.5mm amplitude 9 up to 500Hz, 10m/s , for packaged boards Shock and vibration figures pertain to the motherboard alone and do not OTICE include additional components such as heat sinks, memory modules, cables etc. page 72 ADL Embedded Solutions ADLE3800SEC...
100°C. Permanent overheating may destroy the board! In case the temperature exceeds 100°C the environmental temperature must be reduced. Under certain circumstances sufficient air circulation must be provided. ADL Embedded Solutions ADLE3800SEC page 73...
(POST code card). The meaning of these codes is described in the document "Aptio™ 4.x Status Codes" by American Megatrends®, which can be downloaded from their website http://www.ami.com. The following additional OEM POST codes are generated: Code Description BIOS-API started PCA9535 started PWRCTRL-Firmware started ADL Embedded Solutions ADLE3800SEC page 75...
Need help?
Do you have a question about the ADLE3800SEC and is the answer not in the manual?
Questions and answers