Advertisement
TELEMANN mains voltage selection / fuse
replacement
The following work should only be carried
!
out by a qualified technician in accordance
to highest electrical safety standards. Risk of
electric shock.
Replacing the fuse
The fuse must be replaced by a 0.63AT type
(5x20mm). Never attempt to short the fuse
holder. Normally the fuse should never blow – if
it has, it is a sign of a serious fault condition.
Further investigation is needed.
Mains voltage
Altering the mains input voltage range from
115V to 230V or vice versa is done by changing
the fuses according to the figure 5 below. You
will need 1x 0,63AT (= F1) for 230 V operation
and 2x 0,63AT (= F2 and = F3) for 115V operation.
Never
attempt
to
apply
any
other
fuse
configuration or a short circuit condition will
occur.
22
Advertisement
