Table of Contents
Advertisement
3.3.4 Removing the motor board
(See Fig.8)
(1) Remove the two screws D attaching the motor board.
(2) Remove the spacer fixing the motor board and tray switch-
board, and disconnect the connector
board.
(3) Disconnect the card wire from connector
board.
Caution:
When reconnection the card wire, let the card wire through the
slot d of the motor board and attach it to bottom of the body us-
ing a double face tape.
3.3.5 Removing the DVD tramecha assembly
(See Fig.9)
(1) Remove the three screws E attaching the DVD tramecha
assembly.
1-18 (No.MB506)
CN2
on the motor
CN2
CN1
on the motor
CN1
E
Soldering point
D
d
Fig.8
E
DVD Tramecha assembly
Fig.9
D
Motor
Double
face tape
Card wire
E
Advertisement
Table of Contents
