Installation Precautions - Pioneer S-DV77SW Operating Instructions Manual

Installation Precautions

• Install components so that there are no obstructions above or
either side of them, or by ventilation holes. Also install 5cm
away from the wall as shown in the figures. Components feature
ventilation holes on the bottom so do not install on thick pile
carpets or other surfaces that may block them.
• Use a vacuum cleaner periodically to clean the port of the
subwoofer to keep it free of dust.
Powered subwoofer unit (S-DV77SW)
5 cm or more
DVD/CD Tuner (XV-DV77)
5 cm or more
15 cm or more
6
PLAY/PAUSE
STANDBY/ON
5 cm or more
5 cm or
0
OPEN/CLOSE
R 1
more
STOP 7
LINE VOLTAGE SELECTOR SWITCH
( Multi voltage model only)
The line voltage selector switch is located on the rear panel. Check that
it is set properly before plugging the power cord into the outlet. If the
voltage is not properly set or if you move to an area where the voltage
requirements differ, adjust the selector switch as follows:
• Be sure to disconnect the power cord from its outlet before making
this adjustment.
• Use a medium-sized (flat blade) screwdriver. Insert the tip of the
screwdriver into the groove of the selector switch and turn it so that
the power voltage marking of your area points to the arrow.
110 V
-120 V
220 V
-230 V
240 V
VOLTAGE SELECTOR
CAUTION 220 – 230 V
Power source voltage is factory adjusted 220 - 230 volts. If your
area is different, change voltage selectors settings.
POWER-CORD CAUTION
Handle the power cord by the plug. Do not pull out the plug by tugging the
cord and never touch the power cord when your hands are wet as this could
cause a short circuit or electric shock. Do not place the unit, a piece of
furniture, etc., on the power cord, or pinch the cord. Never make a knot in
the cord or tie it with other cords. The power cords should be routed such
that they are not likely to be stepped on. A damaged power cord can cause a
fire or give you an electrical shock. Check the power cord once in a while.
When you find it damaged, ask your nearest PIONEER authorized service
center or your dealer for a replacement.
H038 En
3
En