Advertisement
Please do not ride in poor light places. If you have to, please slow down and pay more attention.
Please avoid riding backwards, it's dangerous. It can only be accepted to ride a few steps to keep away from sudden block.
Positive safe protection measures:
Before each ride, make sure that all locking parts are locked well (follow instructions to avoid injury during folding and unfolding,
like jamming your fingers)
Before each ride, please carefully check all the screws status, in case of self-locking nut or other fixed parts failures.
Please carefully check if the scooter frame is weld-opening, desoldering, fracture, distortion or other situations. If yes, please do not drive to avoid the danger.
The tire should be inflated well, and has sufficient anti-skid tire treads.
Axle jackets and other protective equipment should be located in place.
Before driving, users should prepare and do the inspections following the manufacturers' instructions:
Wear helmet, knee pads, gloves, elbow protection and other protective equipment.
Riding places are suitable for safe riding and operation.
Brake system is working well.
The safety label is located in place and easy to understand.
Please read the manual carefully and understand the content.
Do not let other people ride your L1 e-scooter unless he/she has read the manual carefully.
15
Safety protection is necessary in riding, please make sure you wear suitable helmets (with hatband), gloves, eye care devices, kneepads and elbows.
Do not ride when you feel uncomfortable or cannot follow the rule and notice of the manual; Also do not ride when you drink alcohol or take medicine.
When battery power is low or scooter keeps alarming or the speed is limited, please get off and charge in time to keep safe.
Do not lift the scooter from the tire position to avoid the harm that fingers may get stuck between tire and cover.
Please exam the scooter before riding, do not ride it when there is loose or damage problems.
Please accelerate slowly to avoid sudden speed, which may cause unbalance, falling down and getting injured. This kind of ride habit is dangerous, most of
accidents result from it.While riding, you may have sudden dangers, so please take good care during your ride. RIDE AT YOUR OWN RISK AND USE COMMON
SENSE. The manufacturer won't take the responsibility because of improper use and do not follow the manual guidance that may cause body hurt.
L 1 M a i n t e n a n c e
The bearing will get dirty after a certain time's using, which will affect the scooter gliding. Need to remove the bearing and clean.
The normally used cleaners are neutral diesel or kerosene without water. Sometimes use warm lye to clean depending on needs.
Either cleaner with filter should always be kept clean.
The tire should be replaced when it is broken or badly worn. Use allen wrench to replace the tire. First loose the two-side screws with the wrench,
then pull out the lock nut to remove the wheel.
The tire pressure can not exceed 35PSI.
Silicone oil lubrication is recommended.
Use replacement parts which the original manufacturer permits, and make it installed by the distributor or technician.
When the electromagnetic brake is not working, contact the agent for replacing.
16
Advertisement
