Environment Avoid dust, oil fog and corrosive gases Ambient Temperature 0 ℃ - 50℃ The M542 is an economical microstepping driver based on patented technology of Leadshine. It is Operating Environment Humidity 40%RH - 90%RH suitable for driving 2-phase and 4-phase hybrid stepping motors. By using the advanced bipolar Operating Temperature ℃...
The following tables are brief descriptions of the two connectors of the DC power ground M542. More detailed descriptions of the pins and related issues are presented in section 4, 5, 9. DC power supply, 20~50VDC, Including voltage fluctuation and EMF Connector P1 Configurations voltage.
5. Connecting the Motor motors should be run at only 70% of their rated current to prevent over heating. The M542 driver can drive any 2-pahse and 4-pahse hybrid stepping motors. Connections to 4-lead Motors 4 lead motors are the least flexible but easiest to wire. Speed and torque will depend on winding Figure 7: 6-lead motor full coil (higher torque) connections inductance.
7. Selecting Microstep Resolution and Driver Output Current The M542 can match medium and small size stepping motors (from Nema size 17 to 34) made by This driver uses an 8-bit DIP switch to set microstep resolution, and motor operating current, as Leadshine or other motor manufactures around the world.
M542 Economical Microstepping Driver Manual V1.0 M542 Economical Microstepping Driver Manual V1.0 closest to your motor’s required current. 9. Typical Connection Dynamic Current Setting A complete stepping system should include stepping motor, stepping driver, power supply and Peak current (A) RMS (A) controller (pulse generator).
Automatic current reduction function not being utilized In the event that your M542 doesn’t operate properly, the first step is to identify whether the problem is electrical or mechanical in nature. The next step is to isolate the system component that Current is set too high is causing the problem.
Please include a written description of the problem along with contact name and address. Send failed product to distributor in your area or: Leadshine Technology Co., Ltd. Floor 3, Block 2, Nanyou Tianan Industry Park, Nanshan Dist, Shenzhen, China. Also enclose information regarding the circumstances prior to product failure.
Need help?
Do you have a question about the M542 and is the answer not in the manual?
Questions and answers