Table of Contents
Summary of Contents for RF Tecnnologies RF1060
-
Page 1: Operating Instructions
R.F. TECHNOLOGIES, INC. RF1060 Headset OPERATING INSTRUCTIONS Brought To You By The Drive-Thru Experts SINCE 1989 24-Hour Customer Service & Technical Support 1.800.598.2370 www.rftechno.com For Use With 3M C1060 Drive-Thru Systems... - Page 2 Repair and Purchase Information FCC INFORMATION This device complies with part 15 of the FCC Rules listed ID TOM-RF1060. IC # 9830A-RF1060. WARRANTY INFORMATION Operation is subject to the following two conditions: The RF1060 All-In-One headset contains (1) This device may not cause harmful interference, a 1 year warranty.
- Page 3 CONTROlS & INDICATORS : RF1060 Headband Adjustment Headband Support Slide Jacket Prevents Headband From Separating From Case On/Off Switch Battery Side Indicator LED Battery Release (Talk Lane 2) Switch Talk Lock Switch (Hands Free) Battery (Talk Lane 1) Switch Page Switch...
- Page 4 OPERATION Turning On The Press the ON switch located on the inside of the headset. A single tone will Headset sound and the LED indicator will glow green to indicate the headset has been turned on Operating Modes single-lane, dual-lane, standard communication, duplex communication Standby Mode Standby enables the headset to wait for menu sign or other headset communcation...
- Page 5 OPERATION (CONT.) Talk Lock Mode Use this to operate “hands free”. This feature only available with duplex system “Hands Free” configurations. The headset automatically switches from standby to talk/listen when a cus- tomer is detected at menu sign. Headset automatically switches back to standby when customer leaves menu sign.
- Page 6 MAINTENANCE Replacing The A short, low-volume tone is heard at seven-second interals when the battery Battery voltage is low. Tone continues for 2 minutes, then headset turns off. Insert fully charged battery when warning tones are heard. Make sure batteries are fully charged prior to use TO REPLACE BATTERY: 1.
- Page 7 Enabling / Disabling TO ENABLE OR DISABLE TALK LOCK FEATURE: The Talk Lock Feature 1. Turn headset off 2. Press and hold talk lock button while pressing and holding the ON but- ton until audible tones are heard. This indicates features has been enabled / disabled.
Need help?
Do you have a question about the RF1060 and is the answer not in the manual?
Questions and answers