Advertisement
Quick Links
StompLight Professional DMX Effect Pedal Owner's Manual
Congratulations on your purchase and commitment to your art and your audience!
You will find a registration sticker on the base of your StompLight product. Please go to
www.StompLight.com and register your StompLight to secure your warranty.
Only use the StompLight® power adapter that came with your product.
Do not plug a microphone / or an audio source into the DMX jacks on your StompLight products.
1. Unplug your StompLight® power adapter at the rear panel or switch off the Power Bank.
2. Wait 10 seconds
3. Plug-in the StompLight Professional or switch on the Power Bank while holding down the
ON/Off Switch.
4. This will restore StompLight to the factory settings.
In this Owner Manual Active Powering means plugging in and powering up. This is different than
turning your StompLight On/Off using the footswitch. To power up your StompLight plug in the
included StompLight 12-volt 1.5 amp center-positive Power Adapter to a standard power source.
When the unit is actively powered the
Status Light
StompLight® powers up in the Color Wheel Mode (the first of 5 modes available) and with the LED
Lighting Array turned off. StompLight products can also be powered with the optional StompLight
Lithium Ion Power Bank providing hours of "unplugged" operation. If you want to order a StompLight
Power Bank check with your local music store first. If they do not have StompLight® Power Bank
grab one on
www.StompLight.com
Take Heed!
You are going to need a bigger tip jar!
These jacks are for DMX connection only.
Restoring Factory Default Settings
Active Powering your StompLight
Status Light
on the control surface will glow.
v7.17
1
Advertisement
Summary of Contents for StompLight DMX
- Page 1 You are going to need a bigger tip jar! Only use the StompLight® power adapter that came with your product. Do not plug a microphone / or an audio source into the DMX jacks on your StompLight products. These jacks are for DMX connection only.
- Page 2 - In this mode StompLight® will cycle through a full spectrum of colors at a rate you choose. This is the set it and forget it mode. Stage your Stomplight and uplight your performance area using this mode and StompLight will move through colors creating dynamic stage lighting.
- Page 3 Blue Purple Note the Status LED will display the selected color. TIP: If you are in this mode and StompLight® lighting array is turned off you will see the color currently selected on the Status LED. Internal Microphone/Sound Active Mode - In this mode StompLight®...
- Page 4 User Configuration Chart and on the bottom decal on StompLight. With the exception of Slave/Client Mode your User Configs will be stored for next time when you power down. You can restore factory settings by holding down the ON/OFF switch when powering up.
- Page 5 2. Choose which StompLight DMX Professional effect pedal will be the Controller and power it 3. Locate the DMX out connector on the rear panel of the StompLight DMX Pro you selected as the Controller. Using DMX 3-pin cable, “daisy chain” the additional StompLight DMX...
- Page 6 DMX devices like the StompLight Pal or other DMX RGB lighting units it sends a signal to the other devices telling them what to do. Important to note that if you already have a DMX Controller and want your StompLight DMX Professional Effect Pedal to work as a Slave you must power up your StompLight Pro in Slave/DMX Client Mode.
- Page 7 DMX terminator installed, particularly if the chain is over 20 feet long. One or two units with short cables will probably work fine without the DMX terminator. The maximum number of DMX fixtures on a single chain is 32. The maximum length is about 1500 feet.
- Page 8 StompLight Pal highlighting their artistic area. Take caution in the angle and brightness. Less is more. A couple StompLight Pros set as a side fill or placed in the front of a band/DJ will add exciting color with independent control.
- Page 9 Refund and Exchange Policy If you are not satisfied with your StompLight® product, email us. We will work like crazy to make you a satisfied customer. There is a 15% restocking fee and your order must be returned in pristine condition.
Need help?
Do you have a question about the DMX and is the answer not in the manual?
Questions and answers