Installation - AEG L82470BI User Manual

24 www.aeg.com
Problem
You cannot open the ap-
pliance door.
The appliance makes an
unusual noise.
The washing results are
not satisfactory.
You cannot set an op-
tion.
After the check, activate the appliance.
The programme continues from the
point of interruption.
If the problem occurs again, contact the
Authorised Service Centre.

14. INSTALLATION

14.1 Unpacking
WARNING!
Remove all the packaging and the transit bolts before installing the
appliance.
Possible solution
• Make sure that the washing programme is finished.
• Set the drain or the spin programme if there is water in the
drum.
• Make sure the levelling of the appliance is correct. Refer to
'Installation'.
• Make sure that the packaging and/or the transit bolts are
removed. Refer to 'Installation'.
• Add more laundry in the drum. The load may be too small.
• Increase the detergent quantity or use a different deter-
gent.
• Use special products to remove the stubborn stains before
you wash the laundry.
• Make sure that you set the correct temperature.
• Decrease the laundry load.
• Make sure that you press only the wanted button(s).
If the display shows other alarm codes.
Deactivate and activate the appliance. If
the problem continues, contact the
Service.
Use the gloves. Remove the external film. If
necessary, use a cutter.